Delkin Devices EI - 25-1 manual Glass Door, Placement of Brick Panels

Page 15

EURO 25 -1

15

INSTALLATION INSTRUCTIONS - Continued

GLASS DOOR

WARNING: Glass door is fragile. Do not strike or abuse glass. Do not operate appliance with broken glass. Do not attempt to fix a broken glass door. It must be replaced with an identical one from the manufacturer. Do not attempt to remove the glass door when the appliance is hot.

Removing the Glass Door

Remove the louvers by lifting and unhooking it off the appliance. Remove the control cover by sliding it off the bottom door assembly. There is a buckle latch located in the bottom centre - lift the lever on the back of the latch to release it. Unhook the latch from the bottom of the door and swing the bottom of the door towards you. Lift up the door to unhook it from the body. Place the door at a safe location where it cannot be scratched or damaged.

Replacing the Glass Door

The reverse procedure of Removing the Glass Door.

LOUVRES

DOOR HOOKS

BUCKLE LATCH

CONTROL COVER

 

PLACEMENT OF BRICK PANELS

Remove the ‘Z’ shape panel clips on the left and right side of the firebox.

Carefully place the panels into the firebox. There are three panels: a center, a left and a right panel. Place the center panel to the back of the firebox. The tapered end of the side panels are towards the back of the firebox. Tilt the panels to pass them through the door opening. Slide the bottom of the panels in place first, and then tilt the panels upright into position. Push the panel to the back. Re-attach the ‘Z’ shape panel clips to the firebox.

LEFT PANEL

RIGHT PANEL

PANEL CLIP

PANEL CLIP

CENTER PANEL

Image 15
Contents Euro 25 Page Introduction Euro 25 Table of Contents Safety General Information Installation CodesSpecifications High Altitude InstallationFront View Surround Sparker Removable Control Cover Appliance Description & DimensionsClearances to Combustibles Installation InstructionsInstallation Instructions 15 ¼ 387 mm Venting PrecautionsGAS Connections VentingAttachment of Fireplace Surround Spill Switch is Connected to the Appliance FACTORY-WIREDGlass Door Placement of Brick PanelsLOG Placement LOG Placement Euro 25 PIN Hole for LOG # Euro 25 Operation Instructions For Your SAFETY, Read Before Lighting Initial OperationSTART-UP Procedure Temporary SHUT-DOWN ProcedureComplete SHUT-DOWN Procedure Cleaning the Appliance MaintenanceSymptom Action TroubleshootingTroubleshooting Servicing Servicing Under WarrantyAdjusting Primary AIR Pilot AdjustmentValve Connections Replacement of FANConvertible Pilot Orifice Replacing GAS Component AssemblyReplacing Major GAS Components Changing Main Burner OrificeAppendix a Precautions½ to 7 ½ 15 ¼ 387 mm Vent Gasket Connector Kit BCV4-KIT or BCV5-KIT Sample Warning Label Sample Modification Warning PlateCanadian Heating Product Model Montigo 28 Series Installation InstructionsFirehearth / Monterey Model Firesong 220 Series Gasglo Model GG 28 Series Archgard T-100 Series FMI Model 850 Series Natural GAS Important InformationArchgard Limited Warranty Item # Description QTY Unit Replacement Parts for EuroEuro 25 Warranty Registration Beatty Drive MISSION, B.C. Canada