Delkin Devices EI - 25-1 manual Operation Instructions

Page 21

EURO 25 -1

21

OPERATION INSTRUCTIONS

FOR YOUR SAFETY, READ BEFORE LIGHTING

INITIAL OPERATION

Check that the appliance is properly vented and connected to the gas supply.

Check that the logs and branches are properly placed.

Check all external parts, such as grills, door and control cover are properly attached and fastened.

NOTE : When operated for the first few times, the appliance will emit odors and fumes. This is due to the evaporation of oils and solvents used in fabricating the appliance. Close off the room to the rest of the house and open all windows. Keep the room well ventilated. Operate the appliance continuously on high setting for at least 4 to 6 hours. This will ‘burn-in’ the appliance and reduce the chance of odors and fumes reoccurring the next time the appliance is used. You may have to repeat the ‘burn-in’ procedure a few times.

WARNING : If you do not follow these instructions exactly, a fire or explosion may result, causing property damage, personal injury or loss of life.

A.

This appliance has a pilot which must be lit by hand using the sparker located next

 

to the appliance valve controls. When lighting the pilot, follow the start-up

 

procedures exactly.

B.

BEFORE LIGHTING, smell all around the appliance area for gas. Be sure to smell

 

next to the floor, because some gases are heavier than air and will settle on the

 

floor. IF YOU SMELL GAS, follow the instruction on the front cover of this

 

manual.

C.

Use only your hand to push in or turn the gas control knob. Never use tools. If the

 

knob will not push in or turn by hand, don’t try to repair it. Call a qualified service

 

technician. Force or attempted repair may result in a fire or explosion.

D.

Do not use this appliance if any part has been under water. Immediately call a

 

qualified service technician to inspect the appliance and to replace any part of the

 

control system and any gas control which has been under water.

Image 21
Contents Euro 25 Page Introduction Euro 25 Table of Contents Safety Specifications Installation CodesHigh Altitude Installation General InformationFront View Surround Sparker Removable Control Cover Appliance Description & DimensionsClearances to Combustibles Installation InstructionsInstallation Instructions 15 ¼ 387 mm Venting PrecautionsGAS Connections VentingAttachment of Fireplace Surround Spill Switch is Connected to the Appliance FACTORY-WIREDGlass Door Placement of Brick PanelsLOG Placement LOG Placement Euro 25 PIN Hole for LOG # Euro 25 Operation Instructions For Your SAFETY, Read Before Lighting Initial OperationSTART-UP Procedure Temporary SHUT-DOWN ProcedureComplete SHUT-DOWN Procedure Cleaning the Appliance MaintenanceSymptom Action TroubleshootingTroubleshooting Adjusting Primary AIR Servicing Under WarrantyPilot Adjustment ServicingValve Connections Replacement of FANReplacing Major GAS Components Replacing GAS Component AssemblyChanging Main Burner Orifice Convertible Pilot OrificeAppendix a Precautions½ to 7 ½ 15 ¼ 387 mm Vent Gasket Connector Kit BCV4-KIT or BCV5-KIT Sample Warning Label Sample Modification Warning PlateCanadian Heating Product Model Montigo 28 Series Installation InstructionsFirehearth / Monterey Model Firesong 220 Series Gasglo Model GG 28 Series Archgard T-100 Series FMI Model 850 Series Natural GAS Important InformationArchgard Limited Warranty Item # Description QTY Unit Replacement Parts for EuroEuro 25 Warranty Registration Beatty Drive MISSION, B.C. Canada