Delkin Devices EI - 25-1 manual Maintenance, Cleaning the Appliance

Page 23

EURO 25 -1

23

MAINTENANCE

CAUTION : Maintenance should only be conducted on a cold appliance.

CLEANING THE APPLIANCE

The exterior painted surfaces, glass and gold trims may be cleaned with a soft, non-abrasive cloth and water or a suitable, mild, non-abrasive cleaner.

Regularly:

Clean and remove any lint accumulations or debris from the grills and in any combustion and convection air passageways.

Keep the appliance area free from combustible materials, such as paper, wood, clothing, gasoline and flammable solids, liquids and vapors.

Visually check the height and color of the burner and pilot flames.

Check for unusual noise, odor and operation of the appliance.

Check the vent terminal for any damage, or obstruction by plants or debris accumulation.

Once a year:

Remove the glass door and clean the inside of the glass with specially formulated ceramic glass cleaner, and a non-abrasive cloth, available from your local dealer.

Carefully remove the logs and, if present, gently brush off any loose carbon deposits. This job is best done outside the house, wearing a dust mask.The logs are very fragile; take care not to break them. After cleaning, the logs must be replaced as per the instructions in this manual.

Once a year, have a qualified service technician:

Completely inspect the appliance and the venting system.

Clean and remove any lint accumulations or debris in the firebox, on the burners, on the pilot, at the primary air opening, on the convection air blower and in any combustion and convection air passageways.

Check the safety system of the gas valve.

WARNING: All parts removed or disturbed must be properly replaced after maintenance. Service and repair must be conducted by a qualified service person. If these instructions are not followed, a fire or explosion may result, causing property damage, personal injury or loss of life.

Image 23
Contents Euro 25 Page Introduction Euro 25 Table of Contents Safety General Information Installation CodesSpecifications High Altitude InstallationFront View Surround Sparker Removable Control Cover Appliance Description & DimensionsClearances to Combustibles Installation InstructionsInstallation Instructions 15 ¼ 387 mm Venting PrecautionsGAS Connections VentingAttachment of Fireplace Surround Spill Switch is Connected to the Appliance FACTORY-WIREDGlass Door Placement of Brick PanelsLOG Placement LOG Placement Euro 25 PIN Hole for LOG # Euro 25 Operation Instructions For Your SAFETY, Read Before Lighting Initial OperationComplete SHUT-DOWN Procedure START-UP ProcedureTemporary SHUT-DOWN Procedure Cleaning the Appliance MaintenanceSymptom Action TroubleshootingTroubleshooting Servicing Servicing Under WarrantyAdjusting Primary AIR Pilot AdjustmentValve Connections Replacement of FANConvertible Pilot Orifice Replacing GAS Component AssemblyReplacing Major GAS Components Changing Main Burner OrificeAppendix a Precautions½ to 7 ½ 15 ¼ 387 mm Vent Gasket Connector Kit BCV4-KIT or BCV5-KIT Sample Warning Label Sample Modification Warning PlateCanadian Heating Product Model Montigo 28 Series Installation InstructionsFirehearth / Monterey Model Firesong 220 Series Gasglo Model GG 28 Series Archgard T-100 Series FMI Model 850 Series Natural GAS Important InformationArchgard Limited Warranty Item # Description QTY Unit Replacement Parts for EuroEuro 25 Warranty Registration Beatty Drive MISSION, B.C. Canada