Desa L32, L36, L32, L36, VL36, L42, L36, L42, LZPR) Installing Optional Blower Accessories

Page 13

INSTALLATION

Continued

INSTALLING OPTIONAL BLOWER ACCESSORIES

NOTICE: The firebox identifica- tion label (including model num- ber, serial number, clearances, etc.) is located in the right side screen pocket area on the front of the firebox. See Figure 25, page 15.

NOTICE: If a log set is installed in the firebox, disconnect log set from gas supply and remove from firebox. Contact a qualified service person to do this.

Note: Appearance of firebox may vary depending on model.

The blower accessory option for use in the vent- free fireboxes is model BK. Model BK is a rotary squirrel cage type blower with magnetic attach- ment and variable speed control.

The blower is installed by removing the lower face panel. To remove the lower face panel, pull the left and right latches toward the center of the appliance until they are disengaged from their locator holes (see Figure 12).

Models with louvered front panels can also be removed by inserting fingertips between slots and gently pulling out. DO NOT FORCE. The panels are actually held in place by means of a retention dimple embossed on the edge of remov- able panels.

WARNING: If there is a duplex electrical outlet installed in the right side of the bottom of the fireplace base area (see Figure 13), be sure that the electrical power to the outlet is turned off before proceeding with blower installation. Failure to do this may result in serious injury.

1.Attach the power cord to the blower motor by firmly pushing the two female terminals at the end of the power cord onto the two spade ter- minals on the blower motor (see Figure 14).

Lower

Louver

Panel

Figure 12 - Accessing Blower

Compartment (Controls Not Shown

for Clarity)

Duplex Electrical Outlet

Figure 13 - Accessing Duplex Electrical

Outlet Installed in Bottom Right Side of

 

Firebox

 

Spade

Magnetic Strips

Exhaust

 

Terminals

 

Port

 

 

 

Green

 

 

Ground

 

 

Wire

Screw

 

 

Air Flow

 

Direction

Blower

Side View

 

Firebox Bottom

 

Installed

 

 

 

After

 

 

Lower

 

 

Panel

Blower

Magnets

Removed

Location

 

 

Figure 14 - Blower Model BK

115254-01A

www.desatech.com

13

Image 13
Contents VL36EN, LEN VL32HN, LHNVL32HP, LHP VL36EP, LEPTable of Contents Safety Information Blower Accessory Product FeaturesLocal Codes OperationLocating Firebox Product SpecificationsPlanning Models42 Models Providing Adequate Ventilation AIR for Combustion VentilationDetermining FRESH-AIR Flow for Heater Location Ventilation Air From Inside Building Ventilation AIRInstallation Clearances InstallationVentilation Air From Outdoors Minimum Wall and Ceiling Clearances see ,Example BUILT-IN Firebox InstallationMinimum 16 inches from Side Wall Nails or Wood Screws Nailing Flanges Rough Opening for Installing WallInstalling Cabinet Mantel Installing Firebox Using Optional Accessory MantelsLower Louver Panel Installing Optional Blower AccessoriesDuplex Electrical Outlet Place control knob, provided, onto control shaft see Figure Wiring Diagram Decal 12 Front of BlowerInstalling Fireplace Hood and Screen HARD-WIRING FireboxDuplex Box Handy Box Strain Relief Top View of Rod LayoutInstallation Items Needed Connecting to GAS SupplyVent Pointing Down Propane/LP Checking GAS ConnectionsNatural Test Pressures Equal To or Less Than 1/2 Psig 3.5 kPa Test Pressures In Excess Of 1/2 Psig 3.5 kPaSupply Tank Correct all leaks at onceVintage Oak Two-Piece Log Set Installing LogsLog #2 Log #1 Front Post Chassis PostMetal Ember Bed Base AssemblyPost Metal PostPlace top left log on middle log as shown in Figure Operating FireplaceTop Left Log Top Right Log Middle Left Front Log Right Front LogPress in control knob and turn counter Lighting InstructionsControl Knob Ignitor ButtonREMOTE-READY Models For Your Safety Read Before Lighting Manual Lighting ProcedureVariable Control Operation To Turn OFF GAS To ApplianceBe hot if heater has been running Control Knob Flame Adjustment On Position Follow instructions included with the remote controlOptional Remote Control Optional HAND-HELD Remote OperationThermostat Series Model Ghrctb ON/OFF Series Model GhrcbPilot Flame Pattern Inspecting BurnersFront Burner Flame Pattern Cleaning Logs Cleaning MaintenanceBurner Injector Holder and Pilot AIR Inlet Hole Observed Problem Possible Cause Remedy TroubleshootingLow gas pressure Assembly Clean ODS/pilot seeLeased Long enoughObserve minimum installa When burners are lit Position when burners areBurner backfiring during com Bustion DamagedGas leak. See Warning Wiring Diagram SpecificationsMaximum Minimum Shipping Weight 104 lbs 184 lbs REMOTE-READY Models onlyTechnical Service Service HintsReplacement Parts Parts Under WarrantyAccessories Illustrated Parts Breakdown Parts Available not Shown Parts List46 39 Parts List 23/24 Not Shown 110314-05 Crossover Log Illustrated Parts Breakdown and Parts ListKEY LOG Part Numbers VL36 Models VL42 Models Description QTY Keep this Warranty Warranty InformationLimited Warranty VENT-FREE Fireplace