Desa L32, L36 L36, L42, L32, L36, L36, L42 Locating Firebox, Product Specifications, Planning

Page 5

LOCATING FIREBOX

PLANNING

Plan where you will install the ﬁrebox. This will save time and money later when you install the ﬁre- box. Before installation, consider the following:

1.Where the ﬁrebox will be located. Allow for wall and ceiling clearances (see Installation Clearances, page 9).

2.Everything needed to complete installation.

3.These models CANNOT be installed in a bedroom unless the maximum Btu rating of the installed vent-free log set is less than 10,000 Btu/hr.

4.Proper air for combustion and ventilation (page 7).

PRODUCT SPECIFICATIONS

32" MODELS

Left Side
View with
Air Kit	Outside Air
	Kit Location
	(Optional)
	221/2"
	4"
	Firebox Top View

5/8"

251/8"

	19 1/2"
2 13/16"	16 11/16"

291/2"

363/8"

347/16"

12 1/4"

5

Standoffs

41/4"

8 /8"

Right Side

Built-In

Side

View

Nailing

Flanges

Square

19/16"

Gas Line

Access

81/8"

Holes

29/16"

187/16"

163/4"

291/2"

361/2"

31/2"

321/4"

1415/16"

33/8" 65/16"

Electrical	6"	21/4"
Access Hole	815/16"
	93/4"
	93/4"

Front View

Figure 1 - Firebox Dimensions (32" Models)

115254-01A

www.desatech.com

5

Image 5

Contents VL36EN, LEN VL32HN, LHNVL32HP, LHP VL36EP, LEPTable of Contents Safety Information Blower Accessory Product FeaturesLocal Codes OperationLocating Firebox Product SpecificationsPlanning Models42 Models Determining FRESH-AIR Flow for Heater Location AIR for Combustion VentilationProviding Adequate Ventilation Ventilation Air From Inside Building Ventilation AIRInstallation Clearances InstallationVentilation Air From Outdoors Minimum Wall and Ceiling Clearances see ,Minimum 16 inches from Side Wall BUILT-IN Firebox InstallationExample Nails or Wood Screws Nailing Flanges Rough Opening for Installing WallInstalling Cabinet Mantel Installing Firebox Using Optional Accessory MantelsDuplex Electrical Outlet Installing Optional Blower AccessoriesLower Louver Panel Place control knob, provided, onto control shaft see Figure Wiring Diagram Decal 12 Front of BlowerInstalling Fireplace Hood and Screen HARD-WIRING FireboxDuplex Box Handy Box Strain Relief Top View of Rod LayoutVent Pointing Down Connecting to GAS SupplyInstallation Items Needed Natural Checking GAS ConnectionsPropane/LP Test Pressures Equal To or Less Than 1/2 Psig 3.5 kPa Test Pressures In Excess Of 1/2 Psig 3.5 kPaSupply Tank Correct all leaks at onceVintage Oak Two-Piece Log Set Installing LogsLog #2 Log #1 Front Post Chassis PostMetal Ember Bed Base AssemblyPost Metal PostPlace top left log on middle log as shown in Figure Operating FireplaceTop Left Log Top Right Log Middle Left Front Log Right Front LogPress in control knob and turn counter Lighting InstructionsControl Knob Ignitor ButtonREMOTE-READY Models For Your Safety Read Before Lighting Manual Lighting ProcedureVariable Control Operation To Turn OFF GAS To ApplianceBe hot if heater has been running Control Knob Flame Adjustment On Position Follow instructions included with the remote controlOptional Remote Control Optional HAND-HELD Remote OperationThermostat Series Model Ghrctb ON/OFF Series Model GhrcbFront Burner Flame Pattern Inspecting BurnersPilot Flame Pattern Burner Injector Holder and Pilot AIR Inlet Hole Cleaning MaintenanceCleaning Logs Observed Problem Possible Cause Remedy TroubleshootingLow gas pressure Assembly Clean ODS/pilot seeLeased Long enoughObserve minimum installa When burners are lit Position when burners areBurner backﬁring during com Bustion DamagedGas leak. See Warning Wiring Diagram SpecificationsMaximum Minimum Shipping Weight 104 lbs 184 lbs REMOTE-READY Models onlyTechnical Service Service HintsReplacement Parts Parts Under WarrantyAccessories Illustrated Parts Breakdown Parts Available not Shown Parts List46 39 Parts List 23/24 Not Shown 110314-05 Crossover Log Illustrated Parts Breakdown and Parts ListKEY LOG Part Numbers VL36 Models VL42 Models Description QTY Limited Warranty VENT-FREE Fireplace Warranty InformationKeep this Warranty