Desa L32, L36 L36, L42, L32, L36, L36, L42, LZPR) Installing Logs, Vintage Oak Two-Piece Log Set

Page 19

INSTALLATION

Continued

INSTALLING LOGS

(Models (V)L32HN, (V)L32LHN. (V)L32HP and (V)L32LHP

WARNING: Failure to posi- tion the parts in accordance with these diagrams or failure to use only parts speciﬁcally approved with this heater may result in property damage or personal injury.

CAUTION: After installa- tion and periodically thereafter, check to ensure that no ﬂame comes in contact with any log. With the heater set to HI, check to see if ﬂames contact any log. If so, reposition logs according to the log installation instructions in this manual. Flames contact- ing logs will create soot.

Vintage Oak Two-Piece Log Set

It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.

1.Place front log on top of the grate and over front posts on chassis (see Figure 26).

Log #2

Log #1

Front Post

Rear

Chassis Post

Figure 26 - Installing Vintage Oak Two-

Piece Log Set

2.Place rear log on rear of chassis (see Figure 26). Slide log forward so that it sits against rear posts on chassis. IMPORTANT: Make sure logs do not cover any burner ports (see Figure 27).

3.Place lava rock around base of heater if desired.

Two Piece Log Set

Burner Ports

Figure 27 - Installing Vintage Oak Two-

Piece Log Set (Top View)

INSTALLING LOGS Models L36(EN, LEN, EP, LEP) and VL36(EN, LEN, EP, LEP)

WARNING: Failure to posi- tion the parts in accordance with these diagrams or failure to use only parts speciﬁcally approved with this heater may result in property damage or personal injury.

It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.

Note: Your appliance may vary from model shown but log placement will be the same.

1.Place front logs (1L and 1R) on top of grate. Make sure notches in bottom of logs ﬁt over grate prongs (see Figure 28).

2.Rest bottom of center log (#2) behind metal posts on front burner (see Figure 29, page 20). Make sure grooves in bottom of log ﬁt over grate. Bring log forward against metal posts.

Front Logs

Notch

Grate

Prong

Figure 28 - Installing Front Logs

115254-01A

www.desatech.com

19

Image 19

Contents VL36EP, LEP VL32HN, LHNVL36EN, LEN VL32HP, LHPTable of Contents Safety Information Operation Product FeaturesBlower Accessory Local CodesModels Product SpecificationsLocating Firebox Planning42 Models Providing Adequate Ventilation AIR for Combustion VentilationDetermining FRESH-AIR Flow for Heater Location Ventilation Air From Inside Building Ventilation AIRMinimum Wall and Ceiling Clearances see , InstallationInstallation Clearances Ventilation Air From OutdoorsExample BUILT-IN Firebox InstallationMinimum 16 inches from Side Wall Nails or Wood Screws Nailing Flanges Rough Opening for Installing WallInstalling Cabinet Mantel Installing Firebox Using Optional Accessory MantelsLower Louver Panel Installing Optional Blower AccessoriesDuplex Electrical Outlet Place control knob, provided, onto control shaft see Figure Wiring Diagram Decal 12 Front of BlowerTop View of Rod Layout HARD-WIRING FireboxInstalling Fireplace Hood and Screen Duplex Box Handy Box Strain ReliefInstallation Items Needed Connecting to GAS SupplyVent Pointing Down Propane/LP Checking GAS ConnectionsNatural Correct all leaks at once Test Pressures In Excess Of 1/2 Psig 3.5 kPaTest Pressures Equal To or Less Than 1/2 Psig 3.5 kPa Supply TankChassis Post Installing LogsVintage Oak Two-Piece Log Set Log #2 Log #1 Front PostMetal Post Ember Bed Base AssemblyMetal PostLeft Front Log Right Front Log Operating FireplacePlace top left log on middle log as shown in Figure Top Left Log Top Right Log MiddleButton Lighting InstructionsPress in control knob and turn counter Control Knob IgnitorTo Turn OFF GAS To Appliance Manual Lighting ProcedureREMOTE-READY Models For Your Safety Read Before Lighting Variable Control OperationBe hot if heater has been running Optional HAND-HELD Remote Operation Follow instructions included with the remote controlControl Knob Flame Adjustment On Position Optional Remote ControlThermostat Series Model Ghrctb ON/OFF Series Model GhrcbPilot Flame Pattern Inspecting BurnersFront Burner Flame Pattern Cleaning Logs Cleaning MaintenanceBurner Injector Holder and Pilot AIR Inlet Hole Observed Problem Possible Cause Remedy TroubleshootingLong enough Clean ODS/pilot seeLow gas pressure Assembly LeasedBustion Damaged When burners are lit Position when burners areObserve minimum installa Burner backﬁring during comGas leak. See Warning REMOTE-READY Models only SpecificationsWiring Diagram Maximum Minimum Shipping Weight 104 lbs 184 lbsParts Under Warranty Service HintsTechnical Service Replacement PartsAccessories Illustrated Parts Breakdown Parts Available not Shown Parts List46 39 Parts List 23/24 Not Shown 110314-05 Crossover Log Illustrated Parts Breakdown and Parts ListKEY LOG Part Numbers VL36 Models VL42 Models Description QTY Keep this Warranty Warranty InformationLimited Warranty VENT-FREE Fireplace