Desa LHP) (V)L36(EP, LZPR) HARD-WIRING Firebox, Installing Fireplace Hood and Screen

Page 15

INSTALLATION

Continued

HARD-WIRING FIREBOX

NOTICE: A qualiﬁed electrician must connect electrical wiring to duplex outlet for built-in instal- lation. Follow all local codes. In absence of local codes fol- low The National Electric Code ANSI/NFPA 70.

The “Handy Box” with duplex outlet is provided in the ﬁrebox located in the lower right base area.

1.Remove screw holding duplex outlet cover to handy box. Remove duplex outlet.

2.Route electrical cable through strain relief and handy box (see Figure 17).

3.Connect electrical cable to duplex outlet. Match wire colors to those on duplex outlet. Be sure to connect the ground wire.

4.Place duplex outlet back into handy box and secure with screws. Replace outlet cover.

Duplex Box/

Handy Box

Strain Relief

Figure 17 - Hard-Wiring Firebox

INSTALLING FIREPLACE HOOD AND SCREEN

1.Attach hood to ﬁrebox using screws provided (see Figure 18).

2.Insert each rod through all rings located at top of screen.

3.Insert ﬁrst rod into rear hole in left side of ﬁrebox. Fasten rod to rear hole near center of ﬁrebox using #10 x 3/8" Phillips screw provided (see Figure 19).

4.Insert other rod into front hole on right side of ﬁrebox and fasten using remaining Phillips screw.

	Figure 18 - Screw and Hood Placement
	(Model May Vary From Illustration)
	Top View of Rod Layout
	Rear Hole
	Front	Identiﬁcation
	Front	Label Location
	Hole	Label Location
	Hole
	Rod
	Ring
	Screen
		Screw
	Figure 19 - Installing Fireplace Screen
	(Model May Vary From Illustration)

115254-01A

www.desatech.com

15

Image 15

Contents VL36EP, LEP VL32HN, LHNVL36EN, LEN VL32HP, LHPTable of Contents Safety Information Operation Product FeaturesBlower Accessory Local CodesModels Product SpecificationsLocating Firebox Planning42 Models AIR for Combustion Ventilation Providing Adequate VentilationDetermining FRESH-AIR Flow for Heater Location Ventilation Air From Inside Building Ventilation AIRMinimum Wall and Ceiling Clearances see , InstallationInstallation Clearances Ventilation Air From OutdoorsBUILT-IN Firebox Installation ExampleMinimum 16 inches from Side Wall Nails or Wood Screws Nailing Flanges Rough Opening for Installing WallInstalling Cabinet Mantel Installing Firebox Using Optional Accessory MantelsInstalling Optional Blower Accessories Lower Louver PanelDuplex Electrical Outlet Place control knob, provided, onto control shaft see Figure Wiring Diagram Decal 12 Front of BlowerTop View of Rod Layout HARD-WIRING FireboxInstalling Fireplace Hood and Screen Duplex Box Handy Box Strain ReliefConnecting to GAS Supply Installation Items NeededVent Pointing Down Checking GAS Connections Propane/LPNatural Correct all leaks at once Test Pressures In Excess Of 1/2 Psig 3.5 kPaTest Pressures Equal To or Less Than 1/2 Psig 3.5 kPa Supply TankChassis Post Installing LogsVintage Oak Two-Piece Log Set Log #2 Log #1 Front PostMetal Post Ember Bed Base AssemblyMetal PostLeft Front Log Right Front Log Operating FireplacePlace top left log on middle log as shown in Figure Top Left Log Top Right Log MiddleButton Lighting InstructionsPress in control knob and turn counter Control Knob IgnitorTo Turn OFF GAS To Appliance Manual Lighting ProcedureREMOTE-READY Models For Your Safety Read Before Lighting Variable Control OperationBe hot if heater has been running Optional HAND-HELD Remote Operation Follow instructions included with the remote controlControl Knob Flame Adjustment On Position Optional Remote ControlThermostat Series Model Ghrctb ON/OFF Series Model GhrcbInspecting Burners Pilot Flame PatternFront Burner Flame Pattern Cleaning Maintenance Cleaning LogsBurner Injector Holder and Pilot AIR Inlet Hole Observed Problem Possible Cause Remedy TroubleshootingLong enough Clean ODS/pilot seeLow gas pressure Assembly LeasedBustion Damaged When burners are lit Position when burners areObserve minimum installa Burner backﬁring during comGas leak. See Warning REMOTE-READY Models only SpecificationsWiring Diagram Maximum Minimum Shipping Weight 104 lbs 184 lbsParts Under Warranty Service HintsTechnical Service Replacement PartsAccessories Illustrated Parts Breakdown Parts Available not Shown Parts List46 39 Parts List 23/24 Not Shown 110314-05 Crossover Log Illustrated Parts Breakdown and Parts ListKEY LOG Part Numbers VL36 Models VL42 Models Description QTY Warranty Information Keep this WarrantyLimited Warranty VENT-FREE Fireplace