INSTALLATION
Continued
3.Slide groove on back of rear log against the rear grate prongs. Make sure the peg on the log is on top (see Figure 30).
4.Place the crossover log on the rear and middle logs. Make sure peg on rear log is in the hole in bottom of crossover log.The crossover log should fit in cutout of middle log (see Figure 31).
Metal | Center Log (#2) | |
Post | ||
| ||
| Grate | |
| Metal Post | |
Figure 29 - Installing Center Log | ||
| Rear Log | |
| (#3) | |
| Rear | |
| Grate | |
| Prong | |
Figure 30 - Installing Rear Log (#3) | ||
| Crossover | |
| Log (#4) | |
| Peg | |
Figure 31 - Installing Crossover Log (#4)
INSTALLING LOGS
Models (V)L36(ZNR, LZNR, ZPR, LZPR)
and (V)L42(ZNR, LZNR, ZPR, LZPR)
WARNING: Failure to posi- tion the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.
Note: Your appliance may vary from model shown but log placement will be the same.
1.Place ember bed in center of the base assembly as shown in Figure 32.
2.Rest rear log in back corner sections of base as- sembly as shown in Figure 32. Make sure log is completely vertical and not leaning in toward burner where the flame will touch the log.
3.Position middle log as shown in Figure 32 making sure the grooves in the bottom of the log fit over the grate prongs. This log will rest on top of the bottom log.
Middle Log | Rear Log |
|
Ember
Bed
Base 
Assembly
Figure 32- Installing Ember Bed, Rear
and Middle Logs
20 | www.desatech.com |