Continental BCDV42N Finishing, L42 LOUVRE INSTALLATION, Logo Placement, A B A B, FIGURES 40a-b

FIGURES 40a

19

FINISHING

L42 LOUVRE INSTALLATION LOGO PLACEMENT

FIGURE 38

Remove	the
backing of	the
logo supplied and
place on the glass		½"
viewing door, as
indicated.			LOGO

A

B

A

B

HINGE

CLIP

S L O T

TA B

S L O T

UPPER LOUVRES

Insert the louvre tabs into the slots located at the top left and right corners of the unit.

LOWER LOUVRES

Insert the hinge clips into the slots located at the bottom left and right corners of the unit.

To remove the louvres, pull the back tabs of the clips forward, while pushing the louvre assem- bly back. Lift the clip.

½"

FIGURE 39

PORCELAIN REFLECTIVE PANELS

1.Remove the upper louvres, and open the glass door.

Remove the logs.

2.Remove the securing screw al- ready in place at the back of the fire- box. If the unit is supplied with a rear log support, remove before install- ing the rear brick panel. Place the rear panel against the back of the

firebox and re-install the rear log support over the brick panel, if supplied. Secure using the original screw.

3.Remove the two securing screws located on either fire- box side.

4. Place the left brick panel against the left side of the firebox, ensuring that it butts up to the rear panel. Secure in place using 2 of the screws previously removed. Repeat for the right side.

5.Replace the logs, glass door and louvres.

FIGURE 40b

NOTE: MBP42 Shown. Mortar lines not available on PRP42. The appearance of the panels will permanently lighten in colour with use.

FIGURES 40a-b

W415-0385 / A / 10.02.03