Vermont Casting SDV30 manual Venting Requirements Natural Vent Only, Termination Clearances

Stardance Direct Vent/Natural Vent Gas Heater

Termination Clearances

Termination clearances for buildings with combustible and noncombustible exteriors.

Inside Corner Outside Corner Alcove Applications*

			F =
	G =		Combustible
G	Combustible		6"	(152 mm)
	6" (152 mm)	V	Noncombustible
			2"	(51 mm)
	Noncombustible
V			F
	2" (51 mm)

Balcony -	Balcony -
with no side wall	with perpendicular side wall

M	M
V	V
	P
M =	Combustible &
	Noncombustible
Combustible &
	M = 24" (610 mm)
Noncombustible
	P = 20” (508 mm)
12" (305 mm)

D

C C

V

E

O

E = Min. 6” (152 mm) for non-vinyl sidewalls Min. 12” (305 mm) for vinyl sidewalls

O = 8’ (2.4 m) Min.

No.
of Caps	DMin.	CMax.
1	3’ (.9 mm)	2 x DActual
2	6’ (1.8 m)	1 x DActual
3	9’ (2.7 m)	2/3 x DActual
4	12’ (3.7 m)	1/2 x DActual

DMin. = # of Termination caps x 3

CMax. = (2 / # termination caps) x DActual

584-15

*NOTE: Termination in an alcove space (spaces open only on one side and with an overhang) is permitted with the dimensions specified for vinyl or non-vinyl siding and soffits. 1. There must be a 3’ (914 mm) minimum between termination caps. 2. All mechanical air intakes within 10’ (1 m) of a termination cap must be a minimum of 3’ (914 mm) below the termination cap. 3. All gravity air intakes within 3’ (914 mm) of a termination cap must be a minimum of 1’ (305 mm) below the termination cap.

Fig. 10 Termination clearances.

Venting Requirements - Natural Vent Only

(in feet)	unit before any elbow)
Vertical Run	from top of the
	(Measured

��

��

�� A

�� B

��

��

��

��

��

��

��

��

��

��

�

�

�

�

������������������������������������������������������

Venting Runs

NOTE: When venting staight vertical, without any elbow, a minimum of 8 ft. vertical is required

off the top of the stove.

= Acceptable venting configuration = Unacceptable venting configuration

A:Vertical installations up to 36 feet (12m) in height. Up to an 18 ft. horizontal vent run can be installed within the vent system using a maximum of two 90-degree elbows or four 45-degree elbows.

B:Vertical installations up to 36 feet (12m) in height. Up to a 24 ft. horizontal vent run can be installed within the vent system using a maximum of two 45-degree elbows.

(Ratio = 2/3, Hor./Vert.)

Horizontal Run (in feet)

Fig. 11 Vent termination window - Natural Vent ONLY.

NOTE: When using the FSDHAG, the restrictor plate supplied with the stove is not used.

20007065 11