Stardance Direct Vent/Natural Vent Gas Heater
Thermostat Connection (optional)
Use only a thermostat rated for 500 millivolts.
Check the table below for the appropriate gauge ther- mostat wire to use for the length of lead required in your
installation. |
|
Thermostat |
|
Wire / Gauge | Maximum Run |
18 | 20 feet |
16 | 20 - 40 feet |
14up to 60 feet
1.Install the wall thermostat in the desired location and run the wires to the stove location. Terminate these leads with 1/4” female connectors.
2.Connect the thermostat wires to the valve. (Fig. 42)
Install the Front Plate
Hold the front plate by the window bars and lift it into position, engaging the two steel tabs on the top corners behind the adjacent bosses in the side plates. (Fig. 43) Then seat the Front against the sides so the tabs at the bottom lip engage with the notches in the stove legs.
When properly installed, the bottom of the Front Plate cannot be pulled away from the sides without also lifting it .
Engage steel tabs gehind the cast iron bosses
Control Door
Bottom tabs engage |
|
notch in the leg. | ST474 |
Fig. 43 Install the front plate.
This completes assembly of the Stardance stove.
22 | 20007065 |