A
B
C
| OFF | |
| P | |
|
| I |
O | TO | L |
| ||
FC107
Fig. 55 Remove mounting screws, pressure regulator tower and spring and diaphragm assembly.
E
Stardance Direct Vent/Natural Vent Gas Heater
Pilot Hood |
|
Pilot |
|
Bracket |
|
| CO105a |
Fig. 57 Remove pilot hood. |
|
Index Tab | Allen Wrench |
Snap Ring
CO106a
Fig. 58 Remove pilot orifice.
Pilot type 2
O
F
OFF
P
I TO L
D
FC108
•Loosen pilot hood turning counterclockwise using a 7/16” wrench. (Fig. 59) NOTE: You may use pen- etrating oil to prevent pilot hood threads from seizing up.
•Remove pilot orifice with needlenose pliers. (Fig. 60) NOTE: Use a wrench to hold pilot tube in place while removing the orifice.
•Install the conversion orifice.
•Reinstall pilot hood and tighten until mark on pilot hood aligns with mark on pilot bracket.
NOTE: Be sure burner leg remains at a 90° angle to firebox base after conversion.
Fig. 56 Replace regulator.
Pilot Orifice Conversion
1.Locate pilot. (Fig. 53)
2.Replace pilot orifice.
Pilot Type 1
•Remove pilot hood by lifting up. (Fig. 57) Do not remove snap ring to remove pilot hood. NOTE: It is not necessary to remove the pilot tube for conver- sion.
•Remove pilot orifice with Allen wrench. (Fig. 58)
•Install the conversion orifice.
•Reinstall pilot hood. Be sure to align hood with index tab.
20007065
Pilot |
Index |
Marks |
Pilot Bracket |
CO105 |
Fig. 59 Remove pilot hood. (Your pilot may have a different appearance.)
| Pilot Orfice |
| CO106b |
Fig. 60 | Remove pilot orifice. |
| 31 |