Vermont Casting SDV30 Operation, Flame & Temperature Adjustment, Pilot and Burner Inspection

Page 23

Stardance Direct Vent/Natural Vent Gas Heater

Operation

The Stardance is operated with the operable door front plate in place with the doors open or closed. To open the front doors, insert the handle into the door latch stub and turn it to the left and up. (Fig. 44) When not in use, the handle may be stored in the handle holder on the right side of the rear shroud. (Fig. 47)

Clockwise

to Open

Counterclockwise

to Close

 

ST621

Fig. 44

To open the front doors, turn handle clockwise.

 

Handle

 

Holder

 

ST624

Fig. 45

When not in use, store handle in the handle holder.

ST476

Fig. 46 Pilot assembly location.

Flame & Temperature Adjustment

For stoves equipped with HI/LO valves, flame adjust- ment is accomplished by rotating the HI/LO adjustment knob located near the center of the gas control valve. (Fig. 47)

Turn

 

 

 

counterclockwise

LO

HI

Turn clockwise

to decrease

 

to increase

 

 

flame height

 

 

flame height

Fig. 47 Flame adjustment knob for Honeywell valve.

Flame Characteristics

Your First Fire

Read these instructions carefully and familiarize your- self with the burner controls. Locate the pilot assembly, Figure 46. Follow the lighting instructions on Page 24 exactly.

During the first fire, it is not unusual to smell some odor associated with new logs, paint and metal being heated. Odors should dissipate within an hour or so, however, you can open a window to provide fresh air to alleviate the condition.

Pilot and Burner Inspection

Each time you light your heater check that the pilot flame and burner flame patterns are as shown in Figure

54.If flame patterns are incorrect, turn the heater off. Contact your dealer or a qualified gas technician for as- sistance. Do not operate the heater until the pilot flame is correct.

Follow regular maintenance procedures as described on Page 33.

It is important to periodically perform a visual check of the pilot and the burner flames. Compare them to Figure 48. If any of the flames appear abnormal, call a service person.

CO105c

Red Glow

LG143

Fig. 48 Correct pilot and burner flame patterns.

20007065

23

Image 23
Contents What to do if YOU Smell GAS Stardance Direct Vent/Natural Vent Gas HeaterTable of Contents General Information Stardance Direct Vent / Natural Vent Dimensions Materials Installation RequirementsClearance Requirements Minimum Clearances to CombustibleHearth Requirements Wall Centerline from FloorWall and Ceiling Clearances Horizontal Termination Direct Vent only Gas SpecificationsGas Inlet and Manifold Pressures High ElevationsDirect Vent Only Vertical Termination Direct Vent onlyVent Termination Clearances Location of Vent Termination Vent Termination ClearancesGeneral Venting Information Termination Location Canadian Installations1 US Installations2Termination Clearances Venting Requirements Natural Vent OnlyMinimum Horizontal Vent Kit Venting Requirements and OptionsApproved Vent System Components Simpson DuraVent ComponentsRemove rear skirt insert Install the Optional FanVenting System Assemlby Direct Vent General Information Install the Vent Adapter PipeSimpson Dura-Vent install inner adapter pipe Side Wall Termination AssemblyDetermine the vertical pipe length Vent Termination Below Grade Vertical Through the Roof Vent AssemblyInstall firestops and attic insulation shield Venting System Assembly Natural Vent General InformationAged Logs Install the Vent PipeInstall the Log Set Connect the Gas Supply LineBurner Information Air Shutter AdjustmentAir Shutter Adjustment Instructions Install ON/OFF Switch Complete the AssemblyThermostat Connection optional Install the Front PlateThermostat Wire / Gauge This completes assembly of the Stardance stovePilot and Burner Inspection Flame & Temperature AdjustmentFlame Characteristics Your First Fire OperationTo Turn Off Gas To Heater Lighting and Operating InstructionsSymptom Possible Causes Corrective Action Troubleshooting / Honeywell #8420 Gas Control SystemDelay Timer Mode Shut Off ProcedureTransmitter Operation Off Mode On Manual ModeDisable Thermostat Function Auto ModeFan Override During Auto Mode Change Between F/C Temperature UnitsLocal Path Auto Path Models 3900, 3910 R Models Only Honeywell Valve Conversion PrecautionsConversion Procedure Fuel Conversion InstructionsPilot Orifice Conversion Pilot type000-5011 Injector Orifice Size MatrixModels 3940, 3950 RF Models Only All ModelsGlass Replacement MaintenanceLogset and Burner Cleaning and Inspection Cleaning the GlassCheck the Gas Flame Regularly Gasket ReplacementStove Disassembly Inspect the Vent System AnnuallyBLK Wiring DiagramsSDV30 DescriptionStardance Direct Vent/Natural Vent Gas Heater SDV30 Fuel Conversion Kits Optional Accessories Stardance Direct Vent/Natural Vent Gas Heater Stardance Direct Vent/Natural Vent Gas Heater Product Covered by this Warranty Limited Lifetime WarrantyProduit Couvert PAR LA Présente Garantie SI UN Service Sous Garantie EST REQUIS…Model EnerGuide Ratings Fireplace Efficiency % Efficiency Ratings