Vermont Casting 36XDV Operating Instructions, Glass Information, Louvre Removal, Window Frame

XDV Direct Vent Gas Fireplace

Operating Instructions

Glass Information

Only glass approved by CFM Corporation should be used on this fireplace.

•The use of any non-approved replacement glass will void all product warranties.

•Care must be taken to avoid breakage of the glass.

•Do not operate appliance with glass front removed, cracked or broken.

•Replacement glass (complete with gasket and window frame) is available through your CFM Corporation dealer and should only be installed by a licensed qualified service person.

Louvre Removal

To remove louvre
assembly top, pull
louvre up and then		2.
lift out. The louvre
assembly bottom is		Louvre
hinged at the bottom	1.
edge and swings
down. (Fig. 47)

Window Frame			Glass Panel
			FP444
	Fig. 47	Remove louvre assembly
	top.

Window Frame Assembly Removal

1.Turn the fireplace OFF (including the pilot).

2.If the unit has been operating, allow time for the components to cool.

3.Remove louvre assembly top.

4.Open the louvre assembly bottom.

5.Release the two clamps along lower edge of the frame by pulling down on clamp handles. (Fig. 48)

6.Tilt window frame assembly out slightly at the bot- tom, lift the frame up and away from the fireplace.

7.To replace window frame assembly reverse proce- dure.

Glass Cleaning

It is necessary to clean the glass periodically. During start-up condensation, which is normal, forms on the inside of the glass and causes lint, dust and other airborne particles to cling to the glass surface. Also initial paint curing may deposit a slight film on the glass. It is therefore recommended the glass be cleaned

Window Frame

Assembly

Fireplace

Front

Clamps

Glass

Panel

Glass

Panel

Pull

Clamp Hook

Push

Clamp Handle

G584-501

Fig. 48 Window frame assembly removal.

two or three times with a non-ammonia household cleaner and warm water (gas fireplace glass cleaner is recommended). After the initial cleaning process the glass should be cleaned two or three times during each operating season depending on the environment in the house.

Clean the glass after the first two weeks of operation.

Do not clean glass when hot.

Do not use abrasive cleaners.

Do not strike or slam the glass.

Replacement Of

Ceramic Hearth Panels

1.Remove glass.

2.Set left and right panels on hearth and bring towards front of unit. (Fig. 49)

Main Burner Assembly	Ceramic
	Hearth Panel

	Grate	Ember
Ceramic		Material
Hearth	Front Burner
Panel
	Front of Unit	FP1611

Fig. 49 Ceramic hearth panel location.

24 10009383