Vermont Casting 36XDV Electronic Gas Control Valve, XDV Direct Vent Gas Fireplace, 10009383

The EB-1 Electrical junction box has been fitted stand- ard on this model to allow for the easy connection of an optional fan kit.

To connect the EB-1 box to the house electrical supply follow the steps below.

1.Unscrew the retaining screw from the EB-1 base plate and remove the EB-1 assembly from the appliance. (Fig. 9)

2.Remove the front cover of the EB-1 box.

3.Remove the plug socket assembly from the EB-1 box.

4.Feed the supply line in through the EB-1 opening in the side of the appliance and then through the back of the EB-1 assembly. (Fig. 9)

5.Connect the black wire of the power supply line to the brass screw (polarized) of the socket assembly.

6.Connect the white wire of the power line to the chrome screw of the socket assembly.

7.Connect the ground wire of the supply line to the green screw of the socket assembly.

8.Refit the socket assembly back into the electrical box and replace the cover plate. Secure the cable with the clamp on the outside of the EB-1 base plate and refit the EB-1 assembly to the unit with the screw removed in step 1.

XDV Direct Vent Gas Fireplace

INSIDE

Electrical Box

FRONTOFUNIT

OUTSIDE

	OF	UNIT
FRONT		FP580

Fig. 9 EB-1 receptacle.

Electronic Gas Control Valve

This appliance may be fitted with a Synetek ignition module.

Installation of the remote on/off starter switch or wall thermostat on electronic ignition units.

1.Thread the wiring through the holes on the side panels of the appliance. Take care not to cut the wire or insulation on metal edges. Route the wire to a conveniently located receptacle box.

2.Attach the wire to the ON/OFF switch and install the

switch into the receptacle box.

BLACK	L1
WHITE	L2	POWER CORD
	GREEN

PURPLE

PILOT SENSING PILOT IGNITER

CIRCUIT BOARD

YELLOW

		M	P
		O	O
				VALVE
	BLUE
		ORANGE
RED			ON/OFF SWITCH
WHITE			OR
			WALL THERMOSTAT

FP1571

Fig. 10 SIT822 Valve with Synetek electronic control wiring diagram.

10009383 9