Figure 55
2.Place the log, center right (B153). Place the two underside holes of the log over the two pin studs of the bracket support center log on the right. (Fig. 55)
XDV Direct Vent Gas Fireplace
Log Center Right (B153)
Figure 56
LG950
Log Front (B155)
4.Place the log, top right (B154). Place the bottom round hole onto the pin of the rear log at the right. The cross section of the log will rest on top of the center right log. (Fig. 57)
5.Position the log, cross over center (B156) by locating the bottom rectangular slot of this log onto the front log center knob. The other end of the log with the bottom round hole will set on top of the rear log center pin. (Fig. 57)
LG949
3.Place the log, front (B155). Place the two underside holes of the log over the two pin studs of the bracket front log support located at the front of the burner hous- ing. (Fig. 56)
Figure 57
Log Cross Over
Center (B156)Log Top Right
(B154)
Log Rear | Figure 58 |
(B152) | |
| Log Cross Over |
| Center (B156) |
Log Left
Top (B157)
LG952 |
|
|
Volcanic | Log Front | Ember Material |
| ||
Lava Rock | (B155) |
|
Log Right Top (B154)
Log Center Right (B153)
Volcanic Lava Rock
LG951
6.Place the log, front left (B157). Place the bottom rectangular slot of this log onto the knob of the front log at the left. (Fig. 58)
7.Place ember material on top of front burner. Ensure separating the ember material into small pieces approximately 1/2” diam- eter and keep 1/2” space between the ember pieces. (Fig. 58)
8.Place large lava rock onto the two sides of the burner tray as shown in Figure 58.
Do not place any of the lava rock material on the burner housing assembly.
10009383 | 27 |