CFM Corporation DVT44IN, DVT38IN General Venting, Chateau, Location of Vent Termination, 20011956

Chateau™

White or Green	To Pilot Ignitor
Green or White
White or Orange
Orange or White	To Pilot
	Flame Sensor

DC Motor		Pilot		Main
		AF-4000		Module
	Main			Learn
				Button
Black			Power	Orange
			Module	Red
Red				Brown
				Black

Pulse/Continuous

Button

Brown

Brown

Red

Black

I

S

Remote Battery

Back-Up Pack

Remote/Off

Switch

Continuous

Pilot ON/OFF

Switch

Black Gnd Red Black

(SWI) (Optional

(SWI) ON/OFF Switch)

FP1795

AC Adaptor

Extension Harness

Fig. 11 DVT38/44 wiring diagram.

General Venting

Your fireplace is approved to be vented either through the side wall, or vertical through the roof.

•Only CFM Corporation venting components spe- cifically approved and labelled for this fireplace may be used.

•Venting terminals shall not be recessed into a wall or siding.

•Horizontal venting must be installed on a level plane without an inclining or declining slope.

There must not be any obstruction such as bushes, gar- den sheds, fences, decks or utility buildings within 24” (610 mm) from the front of the termination hood.

Do not locate termination hood where excessive snow or ice build up may occur. Be sure to check vent termi- nation area after snow falls, and clear to prevent ac- cidental blockage of venting system. When using snow blowers, make sure snow is not directed towards vent termination area.

Location of Vent Termination

It is imperative the vent termination be located observ- ing the minimum clearances as shown on following page.

14 20011956