Secondary Installation
Figure 41: Once the logs are in place the embers can be placed onto and around the burner to create a realistic look. Bags of ceramic fiber embers and rock wool are provided. The ceramic fiber comes in chunks that are about 2” (51 mm) long. Place them irregularly around the burner. When there is a sparse but even layer of embers, spread the rock wool in the same manner. DO NOT pack this ember material as this could create an
unsafe condition. The pieces should be lightly placed so they don’t completely block any of the small burner ports. DO NOT allow any of the embers to rest against the pilot assembly.
Caution: Use only the type of ember material supplied with this fireplace. Due to the irregular size of the ember material, there may be more than required. Use of other foreign materials on the burners may create dangerous conditions.
Figure 41. Complete log
Figure 42. DV50DX complete log
Figure 42: The DV50DX burning with a good flame.
NOTE: While the glass is still removed, it is recommended that the gas line be purged by lighting the pilot.
When lighting the fireplace for the first time since the log set and embers have
been installed/replaced, watch for ignition at ALL the burner ports. If a long delay is noticed, turn the appliance off and wait for it to cool down. Then remove the glass and rearrange the ember material, making sure none of the burner ports are blocked.
29