Daewoo Split Airconditioning System, DSB-071LH owner manual HOW to Install Batteries

Page 21

OPERATION (CONTINUED)

HOW TO INSTALL BATTERIES

To install the batteries, follow the procedures below:

1.Slide down the cover to access most of the remote buttons. Slide down further to access the battery compartment.

2.Insert two “AAA” size Alkaline batteries following the polarity diagram below.

TIMER
ON/OFF ENTER/	TURBO/MILD
CANCEL

+	–
–	+

BATTERY PRECAUTIONS

The precautions below should be followed when using batteries in this device:

1.Use only the size and type of batteries specified.

2.Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Reversed batteries may cause damage to the device.

3.Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.

4.If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage.

5.Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery manufac- turer’s directions).

CELSIUS TO FAHRENHEIT CONVERSION CHART

CELSIUS	FAHRENHEIT	CELSIUS	FAHRENHEIT

18	64.4	26	78.8
19	66.2	27	80.6
20	68	28	82.4
21	69.8	29	84.2
22	71.6	30	86
23	73.4	31	87.8
24	75.2	32	89.6
25	77

NOTES:

•When operating the remote controller, make sure there are no obstructions between the remote controller and the re- mote sensor.

•After a while the display goes blank to conserve battery power. To check the settings, press the ON/OFF button once.

20

Image 21

Contents DSB-071LH Important Notes Safety InstructionsContents Accessories Supplied with the Unit Basic AccessoriesWall Bracket Concrete Nails Remote Controller Copper TubingAccessories not Supplied with the Unit Optional AccessoriesAccessories 1, 2, 3, 4, 5, 6, 7 Description Qty Material SizeOverview Installation DiagramInstallation Installing the Wall BracketSelecting a Site Brown Blue Blue Black Yellow/Green Mounting the Indoor Unit Connecting Copper Tubes To connect the copper tubes, follow the procedures belowPreparing the Copper Tubing not Included To connect the drain hose, follow the procedures below Connecting the Drain HoseBlack Tubing AIR Purging AIR Purging with Vacuum Pump Test RUNLeak Test Finishing the job EvacuationPump Down Test RUNLCD Remote Controller Air Cleaning FiltersLocation of Controls Indoor UnitIndoor Unit Display Remote Display Remote ControllerSetting the Unit for Remote Operation Connecting the AC CordThree Minute Compressor Delay OperationCelsius to Fahrenheit Conversion Chart HOW to Install BatteriesSET Unit to Quick Mode To SET the Unit to Auto ModeTo SET Unit to Cool Mode FAN SpeedsTo Operate FAN only To SET Unit to Dehumidifier ModeTo Select the FAN Direction To SET Unit to Heat ModeTo SET the OFF Timer Mode To SET the on Timer ModePress the Timer OFF button once to enter the Timer screen Play. For example, if it is 800 P.M.To SET Unit to Sleep Mode To Cancel Sleep ModeEmergency Operation CHANGING/CLEANING the AIR Filters Cleaning the Indoor CoverInsert cleaned or new black fil- ters back into the unit Precautions Care and MaintenanceAfter the Season Before the SeasonTroubleshooting Guide Symptoms Possible Cause Possible SolutionsPush EMERGENCY/REMOTE Model Specifications