Daewoo DSB-071LH, Split Airconditioning System owner manual Brown Blue Blue Black Yellow/Green

Page 8

INSTALLATION (CONTINUED)

INSTALLING THE INDOOR/OUTDOOR WIRE TO THE INDOOR UNIT FOR AC CONNECTION

The Indoor/Outdoor wire is used to supply AC from the Indoor unit to the Outdoor unit. To install the indoor/outdoor wire, follow the procedures below.

1.Open the connection cover on the indoor unit to ac- cess the connection area.

Connection cover

Remove the Connection

Cover.

• Loosen one screw for fixing the Connection Cover.

•Loosen one screw at the Connection Cover.

•Remove the Connection Cover.

Screw

2.Fish the indoor/outdoor wire from the rear of the in- door unit through the front of the unit.

For easier connection, make sure enough wire is pulled through the front.

Use the wire as shown below:

Brown

Yellow/Green

Blue

Blue

Black

3.To connect wires, loosen the screw in the Terminal Block and insert the correct wires like following fig-

ure. Connect the Brown wire to the “L” connection, Yellow/Green wire to the “ ” connection, the Blue wire to “Y” connection, the Blue wire to “1” connec- tion and the Black wire to “2” connection.

NOTES:

•This appliance must be installed according to National power supply requirement.

•If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qual- ified person in order to avoid a hazard.

•Make sure the Indoor unit’s AC cord is not connected to AC power when connecting the indoor/outdoor wire.

•When connecting wires, make sure they are fully insert- ed and minimum copper wire is exposed. If they are not, shorting, overheating, no operation, etc. may occur.

•Be sure to comply with local codes on running a wire from the indoor to the outdoor unit.

L

Y

1

2

Brown

Blue Blue Black

Yellow/Green

7

Page 7 Page 9
Image 8
Page 7 Page 9
Contents DSB-071LH Safety Instructions Important NotesContents Basic Accessories Accessories Supplied with the UnitWall Bracket Concrete Nails Remote Controller Copper TubingOptional Accessories Accessories not Supplied with the UnitAccessories 1, 2, 3, 4, 5, 6, 7 Description Qty Material SizeInstallation Diagram OverviewSelecting a Site InstallationInstalling the Wall Bracket Brown Blue Blue Black Yellow/Green Mounting the Indoor Unit Preparing the Copper Tubing not Included Connecting Copper TubesTo connect the copper tubes, follow the procedures below Connecting the Drain Hose To connect the drain hose, follow the procedures belowBlack Tubing Leak Test AIR PurgingAIR Purging with Vacuum Pump Test RUN Evacuation Finishing the jobTest RUN Pump DownAir Cleaning Filters LCD Remote ControllerLocation of Controls Indoor UnitIndoor Unit Display Remote Controller Remote DisplayConnecting the AC Cord Setting the Unit for Remote OperationThree Minute Compressor Delay OperationHOW to Install Batteries Celsius to Fahrenheit Conversion ChartTo SET the Unit to Auto Mode SET Unit to Quick ModeTo SET Unit to Cool Mode FAN SpeedsTo SET Unit to Dehumidifier Mode To Operate FAN onlyTo SET Unit to Heat Mode To Select the FAN DirectionTo SET the on Timer Mode To SET the OFF Timer ModePress the Timer OFF button once to enter the Timer screen Play. For example, if it is 800 P.M.Emergency Operation To SET Unit to Sleep ModeTo Cancel Sleep Mode Insert cleaned or new black fil- ters back into the unit CHANGING/CLEANING the AIR FiltersCleaning the Indoor Cover Care and Maintenance PrecautionsAfter the Season Before the SeasonPush EMERGENCY/REMOTE Troubleshooting GuideSymptoms Possible Cause Possible Solutions Specifications Model
Top Page Image Contents