Daewoo Split Airconditioning System, DSB-071LH owner manual Mounting the Indoor Unit

INSTALLATION (CONTINUED)

4. Connect the wires to the housing and terminals on	<INDOOR UNIT (Control Box)>
the control board individually according to the out-
door unit connection.

Housing & Terminals on the	Main PCB		Terminals
indoor unit		L		Y	1	2

color of wires

color of wires

Housing A

Brown	Yellow/	Blue	Blue	Black
	Green

BLACK GRAY

BLACK GRAY

Brown	Yellow/	Blue	Blue	Black
	Green

1) 2) 3)

Hausing

A

Housing & Terminals on the		L		Y	1	2
outdoor unit	Housing B		Terminals

The used connection cable connected to indoor and out- door unit must be ;

1)H07RN-F 3G1.5mm2 (NOT INCLUDED)

2)H07RN-F 2G1.5mm2 (NOT INCLUDED)

3)UL2464 AWG22 2G0.75mm2 (INCLUDED IN SET)

MOUNTING THE INDOOR UNIT

The Indoor unit must be mounted before connecting the indoor/outdoor wire, drain hose and copper tubing. To mount, follow the procedures below:

1.The tubing can be extended in 4 directions as shown below. No cutting is necessary for left/rear and right/rear tubing connections. If using left or right tub- ing connections, remove the plastic area with a hack- saw so pipes can go through.

Left

Tubing

Left/Rear

Tubing

Right/Rear

Tubing

Right

Tubing

2.Make sure the drain hose and copper tubing are wrapped with the rubber insulation. Using the tape, wrap the indoor/outdoor wire, copper tubing and drain hose together.

CAUTION:

•Make sure the Indoor unit’s AC cord is not con- nected to AC power when performing these pro- cedures.

•Be sure to comply with local codes on running a wire from the indoor to the outdoor unit.

•DO NOT LET THE INDOOR/OUTDOOR WIRE COME IN DIRECT CONTACT WITH THE TUB- ING OR HOSE!

8