Integra RDC-7.1 Basic Operation of Remote Controller Buttons, To Perform a Macro Operation

Basic Operation of Remote Controller Buttons—Continued

To Operate a Connected Component (Mode Switching)

	On	Standby	TV
			I	Input
	1	2	3	+
	@.-'/	ABC	DEF	TV CH
	4	5	6	-
	GHI	JKL	MNO
	7	8	9
	PQRS	TUV	WXYZ	TV VOL
	+10	0	Clear
	--/---		#
			Direct Tuning
	Custom
				Zone 3
	Macro			Zone 2
Mode	Mode			Input
Scroll wheel	Dimmer			Sleep
	TV	Menu	Men
	Input	op	u
		T	A
		er
		rv	udi
		Se	o A

1	Press the [Mode] button.
	The [Mode] button lights.
2	Roll the scroll wheel.
		Indication on the lower line
		changes to indicate the
		selected component mode.

Before operating the connected component, follow the instructions pages 124 through 133 to make appropriate settings using the remote controller.

Operations

To Select a Source in Zone 2 or Zone 3

Scroll wheel

						1	Press the [Zone 2] or [Zone 3] button.
On	Standby						The [Zone 2] or [Zone 3] button lights.
			TV
		I		Input		2
1	2	3		+			Roll the scroll wheel.
@.-'/	ABC	DEF		TV CH
4	5	6		-			Indication on the upper
GHI	JKL	MNO
7	8	9					line changes to indicate
PQRS	TUV	WXYZ		TV VOL			the selected input.
+10	0	Clear	#
--/---		Direct Tuning
Custom					Zone 3
				Zone 3
Macro				Zone 2	Zone 2	When you perform the procedures on the RDC-7.1,
Mode				Input		press the [Zone 2] (or [Rec/Zone 3]), and press the input
Dimmer				Sleep		source buttons.
TV	enu	M
	M	en
Input	op	u
	T	A
	er
	rv	udi
	Se	o A

To Perform a Macro Operation

	On	Standby	TV
			I	Input
	1	2	3	+
	@.-'/	ABC	DEF	TV CH
	4	5	6	-
	GHI	JKL	MNO
	7	8	9
	PQRS	TUV	WXYZ	TV VOL
	+10	0	Clear
	--/---		#
			Direct Tuning
	Custom
				Zone 3
Macro	Macro			Zone 2
	Mode			Input
Scroll wheel	Dimmer			Sleep
	TV	Menu	Men
	Input	op	u
		T	A
		er
		rv	udi
		Se	o A

Before performing the following procedure, complete your macro settings (See page 137).

1	Press the [Macro] button.
	The [Macro] button lights.
2	Roll the scroll wheel to select the macro’s
	number, and then press the scroll wheel.

Customizing Your Remote Controller

Use the [Custom] button “to enter the remote controller code for another apparatus to this remote controller,” “to make this remote controller learn specified operations from the remote controller for another apparatus,” or “to make this remote controller learn a series of operations with macro functions” according to the configuration you are using. For detailed information, see pages 136-142.

51