Integra RDC-7.1 instruction manual Using the Sleep Timer remote controller only

Connecting the Power/Basic Operations—Continued

Scroll wheel	Macro			Zone 2
	Mode			Input
	Dimmer			Sleep	Sleep
	TV	nu	Menu
		opMe
	Input	T
		ver	Au
	+	er	dio
		S	A
			D
			J
	CH	Enter		VOL
	Disc
	-	E	ide
	Prev	xit	Gu
		R	p
	CH	eturn	Setu
	Display			Muting
	Rec	Main A	Main B	Random
	Audio	Subtitle	Angle	Last Memory
	Surround	THX	All CH ST	Stereo
	Repeat	A-B	Search	Memory
CH SEL	Pure A	Direct	DSP	DSP
	Repeat	Video	Music	Photo	Level–
	Test Tone	CH SEL	Level -	Level +
	Playlist	Album	Artist	Genre	Level+
		Audio SEL	L Night	Re-EQ
	Caps	Delete	Language	Location

RC-554M

RC-555M

Using the Sleep Timer (remote controller only)

With the sleep timer you can set the RDC-7.1 so that it automatically turns off after a set period.

Temporarily Changing the Speaker Output Levels (remote controller only)

To change the individual speaker volumes temporarily, follow the procedure given below. Each channel can be set between –12 and +12 decibels (between –15 and +12 decibels for the subwoofer). Note that the speaker volumes will return to the original settings when the RDC-7.1 is put in the standby state.

1	Press the scroll wheel to enter the
	AMP mode.
2	Press the [CH SEL] button and
	select the desired speaker.
CH SEL
3	Press the [Level –] or [Level +] but-
	ton to adjust the volume level.
Level - Level +

Operations

Remote controller

Sleep

Press the scroll wheel, and then press the [Sleep] button repeat- edly to select the required sleep time.

You can set the sleep time from 90 to 10 minutes in 10 minute increments.

The [SLEEP] indicator appears on the display when the sleep timer has been set, as shown. The specified sleep time appears on the display for about five seconds, then the previous display reappears.

Note:

If you are using the remote zone (Zone 2 or 3), it will turn off at the same time as the main zone.

To cancel the sleep timer, press the [Sleep] button repeatedly until the [SLEEP] indicator disappears.

To check the remaining sleep time, press the [Sleep] button. Note that if you press the [Sleep] button while the sleep time is being displayed, you’ll shorten the sleep time by 10 minutes.

Note:

You cannot select a speaker if it is set to “Not Used” in the Speaker Configuration Sub-menu of the Speaker/ Output Setup Menu.

55