Integra RDC-7.1 Changing the Audio Mode remote controller only, Using the Re-EQ Function

Connecting the Power/Basic Operations—Continued

Changing the Audio Mode (remote controller only)

The RDC-7.1 accepts analog, digital, i.LINK (AUDIO) and multichannel signals for audio input. You can choose the kind of signal to be played for a specific device. For Zone 2, the RDC-7.1 accepts only analog and digital signals for audio input.

1	Input	Press the [Input] button, and then
		roll the scroll wheel to select the

input source you want to set.

2		Press the scroll wheel and then
		press the [Audio SEL] button.
		Each time the button is pressed, the mode
		changes from “Auto” → “Analog”→
		“Multich”→ “i.LINK” and back to
	Audio SEL	“Auto.” The “Auto” audio mode is recom-
		mended for normal circumstances.

Auto (XXX) (automatic detection): With this setting, the RDC-7.1 automatically detects whether the input signal is digital or analog. When a digital signal is not input, then the analog signal is played. This setting only appears if a digital input is selected for the Digital Input setting at Setup Menu → Input Setup Menu → Audio Assign Sub-menu→Digital Audio (See page 99).

(XXX) displays the name of the assigned terminal.

Multich (Multichannel): Select this setting to play back

the input from the component connected to the MULTI-

Using the Re-EQ Function

This function corrects soundtracks with a strong treble level to the home theater level. This correction should be made when the treble sounds from the front speakers are too strong.

Hint:

This can also be set on the menu with OSD. The listening mode which the Re-EQ effect can be applied to has a Re-EQ option in the Listening Mode Setup menu.

1	Press the scroll wheel, and then
	press the [Re-EQ] button (repeat-
	edly).
	Re-EQ

Using the Late Night Function

(only in Dolby Digital)

The difference between loud and quiet sounds is very large in pictures produced for movie theaters, so you have to raise the volume level to catch environmental sounds and human conversations. Since the Late Night Function is able to reduce the difference between loud and quiet sounds, you can hear quiet sounds without raising the entire volume level. This function is helpful when you enjoy movies late at night by turning down sounds. This function is released when putting the RDC-7.1 into the standby status.

Hint:

This function can also be set on the menu with OSD (See page 109).

Operations

CH IN 1/2 port. This setting only appears if “1” or “2” is

selected for the Multichannel setting at Setup Menu →

Input Setup Menu → Audio Assign Sub-menu→Multi-

channel (See page 98).

Analog: Select this setting to playback the input from a

source component connected to analog audio input jacks.

With this setting, even if a digital signal is input from the

same component, only the analog signal will be output.

i.LINK: Select this setting to play back the input from a

source component connected to the i.LINK (AUDIO) ter-

minal. With this setting, only the i.LINK signal will be

output. This settings is available when any device is

selected at Input Setup menu → Audio Assign Sub-menu

→ i.LINK.

1

L Night

Press the scroll wheel, and then press the [L Night] button (repeat- edly).

Off: Turns off the Late Night function.

Low: Reduces the difference between loud and quiet sounds.

High: Further reduces the difference between loud and quiet sounds.

The previous display comes back after a while.

Notes:

•The Late Night function is effective only for Dolby Digital sources.

•The Late Night function may be less effective or have no effect depending on the Dolby Digital source.

57