Integra RDC-7.1 instruction manual 142, Changing the Remote Controller’s Control ID

Other Settings for the Remote Controller—Continued

Changing the Remote Controller’s

Control ID

This section explains how to change the remote control- ler’s ID. You may need to change this if the RDC-7.1’s remote controller interferes with other IntegraRESEARCH/ Onkyo components located in the same room.

Note:

If you change the remote controller’s ID, be sure to select the same ID on the RDC-7.1. For details on setting up the RDC-7.1’s remote control ID, refer to the “Remote Con- trol Setup Sub-menu” section on page 91. The default ID for both the RDC-7.1 and remote controller is 1.

1 Hold down the remote controller’s [Cus- tom] button for more than three seconds.

The remote controller enters Custom mode.

2 Roll the scroll wheel to select “SETUP” menu, and then press the scroll wheel.

3 Roll the scroll wheel to select ID menu, and then press the scroll wheel.

4 Roll the scroll wheel to select an ID—1 (default), 2, or 3—and then press the scroll wheel.

Select the same ID as that set on the

RDC-7.1.

142