Integra RDC-7.1 instruction manual Supplied Accessories, Connecting the Supplied Power Cord

Page 8

Supplied Accessories

Make sure you have the following accessories:

Remote Controller & Three Batteries (AA/R6)

Precautions during unpacking

•The unit is extremely heavy, so be careful when lifting it so as not to cause an injury. Do not lift or move the unit by holding it at the door on the front panel. Doing so may damage the front door.

•When packaged, the door on the front panel is taped to the unit. Before use, be sure to remove this tape.

Taped

AM Loop Antenna (not supplied with USA and Cana- dian models)

AV Controller RDC-7.1

Indoor FM antenna (not supplied with USA and Canadian models)

(connector type varies from country to country)

•The taping for packaging may be different for your product.

Front Left

Front Left

SP-B / Zone 2

Left

SP-B / Zone 2

Left

Front Right

Front Right

SP-B / Zone 2

Right

SP-B / Zone 2

Right

Surround Left

Surround Left

Surround Right

Surround Right

Center

Center

Surround Back

Left

Surround Back

Left

Zone 2

Left

Zone 2

Left

Surround Back Right

Surround Back Right

Zone 2

Right

Zone 2

Right

Front Left

Front Left

SP-B / Zone 2

Left

SP-B / Zone 2

Left

Front Right

Front Right

SP-B / Zone 2

Right

SP-B / Zone 2

Right

Surround Left

Surround Left

Surround Right

Surround Right

Center

Center

Surround Back

Left

Surround Back

Left

Zone 2

Left

Zone 2

Left

Surround Back Right

Surround Back Right

Zone 2

Right

Zone 2

Right

1

2

3

Speaker Cable

Speaker Labels

Connecting the Supplied Power Cord

Plug the supplied power cord into this AC INLET.

•Do not use a power cord other than the one supplied with the RDC-7.1. The power cord supplied is designed for use with the RDC-7.1 and should not be used with any other device.

•Never have the power cord disconnected from the RDC-7.1 while the other end is plugged into the wall outlet. Doing so may cause an electric shock. Always connect by plugging into the wall outlet last and dis- connect by unplugging from the wall outlet ﬁrst.

Power Cord

Power Cord (supplied)

AC INLET

DO NOT connect the power cord at this time.

(plug type varies from country to country)

8

Image 8

Contents RDC-7.1 Important Safety Instructions AvisPrecautions Table of Contents Table of Contents Features Features THX Ultra2Precautions during unpacking Supplied AccessoriesConnecting the Supplied Power Cord Before Using the RDC-7.1 Installing the BatteriesUsing the Remote Controller Remote control sensor RDC-7.1 Standby indicatorIndex Parts and Facilities Front PanelIndex Parts and Facilities Inner Panel Zone 2 button Rec/Zone 3 button 70USA, Canadian, and Australian models European modelsSetup / / /Enter/ / /Exit Tuning ButtonPreset Button Tuning Mode button 62Rear Panel Link S400 Audio terminalsEthernet Net-Tune USAFront Panel Display Remote Controller Amp Mode Direct Tuning button Setup buttonPure a button Test Tone, CH SEL, Level- & Level + buttonsSpeaker Placement Front left and right speakersSpeaker Placement Placing the SpeakersFront Left and Right Speakers, and Center Speaker Left and Right Surround SpeakersSpeaker Placement Suitable for THX Audio SubwooferCorner Room length Layout with dipole speakersCh/2.1 ch Ch/5.1 chCh/6.1 ch/7 ch/7.1 ch with center speaker Ch/3.1 chMain room a Connection ExamplesMain room a Main room B Surr Back Bi-Amp Main room a Power ampliﬁer Connecting a Power AmpliﬁerConnecting a Power Ampliﬁer Using RCA Type Cables Connecting a Power Ampliﬁer Connecting a Power Ampliﬁer Using XLR Type CablesConnecting the output terminal Disconnecting the output terminalHigh range Tweeter Low range Woofer Right speaker Using Bi-amp ConnectionBi-wiring-enabled speakers Attach the FM antenna, as shown Connecting AntennasConnecting the Indoor FM Antenna Connecting Antennas Connecting the AM Loop Antenna Connecting an Outdoor FM AntennaConnecting an Outdoor AM Antenna Using a TV/FM Antenna SplitterAudio cables Connecting AV ComponentsTypes of Connection Cables and Terminals Wrong Right Connecting AV ComponentsVideo cables Connecting Monitors such as TV or Projector Monitor device such as TVFor Main room B For Zone Monitor device such as TV for ZoneConnecting a DVD Player DVD playerConnecting a DVD Recorder or Digital VCR Video Example for connecting with the Video 1 as inputConnecting a VCR Video 2, Video For digitalExample for connecting with the Video 3 as input Connecting a DBS Tuner, DBS TV, or BS/CS Tuner Example for connecting with the Video 4 as inputTurntable Connecting a CD Player, Turntable or TunerCD Player Cassette deck or DAT deck MD recorder or CD recorderWhat is i.LINK What is i.LINK AudioHow to Make a Connection through the i.LINK Audio Interface Copyright Protection SystemInterconnection of i.LINK AUDIO-supported Devices Example RDC-7.1 LINK-ready DVD player i.LINK-ready BS tunerLINK-ready MD recorder Link AUDIO-ready DeviceHow to Conﬁgure i.LINK Connections Using Useful Functions While the i.LINK Connection is ReadyAbout the Hdmi High Deﬁnition Multimedia Interface Connection Using Hdmi TerminalsHow to Make a Connection through the Hdmi Interface Input and Output TV or ProjectorDVD Player with Hdmi Connecting -compatible AV Components Connections for Remote ControlPower on/ready function Power off functionEffective Sensor Layout Effective Sensor ConnectionsUsing an External Device with 12V Trigger Terminal When using the mini-jack 12V Trigger OUT E terminalWire Flatblade USA and Canadian modelsMaking Sensor Connections From connecting blockOther than USA and Canadian models If Remote Controller Signal Does not Reach Other Components Terminal Other than USA Canadian models200 mA D and E 100 mATo Select an Input Source Basic Operation of Remote Controller ButtonsTo Operate the RDC-7.1 AMP Mode Basic Operation of Remote Controller Buttons To Operate a Connected Component Mode SwitchingCustomizing Your Remote Controller To Select a Source in Zone 2 or ZoneOperating on the RDC-7.1 Connecting the Power/Basic OperationsTurning on the Power Turning on the Power from the Remote Controller Connecting the Power/Basic OperationsOperating with Remote Controller Listening with Headphones Adjusting the Brightness of the Front DisplayTemporarily Turning Off the Sound remote controller only Using the Sleep Timer remote controller only Switching the Display Press the Display button onScroll wheel, and then press Dialog normUsing the Late Night Function Only in Dolby Digital Changing the Audio Mode remote controller onlyUsing the Re-EQ Function Using the Listening Modes Types of Listening ModesUsing the Listening Modes IntegraRESEARCH’s Proprietary Listening Mode DSPDolby Headphone Listening Modes for Listeners Using HeadphonesTV Logic Operating on the RDC-7.1 Selecting the Listening ModeOperating with the Remote Controller Listening to Radio Broadcasts Using the TunerTuning into a Radio Station Presetting a Radio Station Selecting a Preset Radio StationErasing a Preset Radio Station Listening to Radio BroadcastsPTY Program Types in Europe Listening to RDS Broadcasts European models onlyListening to RDS Broadcasts Listening to RDS Broadcasts European models only Displaying Radio Text RTPerforming a PTY Scan Performing a TP ScanEnjoying Multichannel Playback How to Set UpHow to Connect Enjoying Multichannel Playback Connecting and Setup Enjoying Movies and Music in the Remote Zone Zone 2/3When Connecting the Power Ampliﬁer Zone 2 or Zone Enjoying Movies and Music in the Remote Zone Zone 2/3Remote Zone Enjoying Movies and Music in aSelect a source Power on the devices in Zone 2 or ZoneAdjust the volume level Video Recording a SourceAudio Recording Audio/Video on a Component While Playing Another Recording a SourceRecording Audio/Video While Playing Main a or Main B mode Check connections and settings toPress the Setup button to display Main Select Input SetupConnecting Net Audio USA, Canada, and Australian models About Net-TuneNetwork Requirements Internet RadioNetworking Your RDC-7.1 Connecting Net Audio Other than USA, Canada, and Australian modelsNet-Tune Central Editing Functions Computer RequirementsLAN port Ethernet, etc About Network ConﬁgurationTo the LAN side port Room TV CH Up/Down/Left/Right / / / & Enter buttons CH/Disc +/- buttonPlay button Previous/Next Buttons Stop buttonEnjoying Internet Radio Erasing a preset Internet radio station Presetting Internet Radio StationsChoosing a Preset Internet Radio Station Press Button to play Music ﬁleTurn on the Net-Tune server Turn on the RDC-7.1Playing a Music File Repeatedly Selecting a Track ListPlaying a Music File At Random Conﬁguring the Music Server Music Server Memo Internet Radio Memo Setup Menu OSD Map Main aSetup Menu OSD Map Main B Main menuReference Pages 100 102OSD Map Zone Navigating the Setup Menu TV Format Sub-menu Hardware SetupRemote Control Setup Sub-menu Speaker/Output Setup Speaker Conﬁguration Sub-menuSpeaker/Output Setup Speaker Crossover Sub-menuSpeaker Distance Sub-menu Notch Filter Sub-menuTHX Audio Setup Sub-menu Level Calibration Sub-menuWhen nothing is connected Select Not Used Audio Output Assign Sub-menuAnalog ExampleVideo Output Assign Sub-menu Opt 1 Out, Opt 2 Out, Coax 1 Out, Coax 2 OutHdmi Out Composite Video 1-3, S-VideoInput Setup Input Setup Audio Assign Sub-menu when input is other than NET AudioAnalog Audio MultichannelMusic Server Sub-menu When input is NET Audio Video Assign Sub-menuListening Mode Preset Sub-menu 100101 Character Edit Sub-menuIntelliVolume Sub-menu Delay Sub-menu102 12V Trigger Assign Sub-menuListening Mode Setup Mono Setup Sub-menuMultiplex Setup Sub-menu 103Listening Mode Setup Stereo Setup Sub-menu104 Multiplex Input Channel105 Direct, Pure Audio Setup Sub-menuMultichannel Input Setup Sub-menu 106 Re-EQLFE Level LINKIEEE1394DVD-Audio Input Setup Sub-menu107 LINKIEEE1394SACD Input Setup Sub-menu 108Dolby Digital Setup Sub-menu 109Late Night Dolby EXDTS Setup Sub-menu 110AAC Setup Sub-menu 111112 Dolby Pro Logic IIx/DTS NEO6 2ch Input only Setup Sub-menu 113THX Setup Sub-menu THX Mode 5ch114 Surround EXTHX Mode 2ch 115All Ch Stereo Setup/Full Mono Setup Sub-menu 116Front Effect Reverb Level117 Dolby Virtual Speaker Setup Sub-menuMode 2ch or 3ch only Dolby Headphone Setup Sub-menu 118Mode Decode 2chTone Control Sub-menu Audio Adjust119 Preference 120Link Setup 121Network Setup 122IP Address Sub-menu Proxy Sub-menu123 Lock/Version SetupNetwork Setup DVD Mode 124125 CD Mode 126Previous/Next / buttons FR/FF ButtonsMiniDisc Mode 127Rec button Eject buttonTape Mode 128Rewind/FF Buttons Reverse Play button129 Using the Remote Controller with Other ComponentsEntering a Remote Control Code Using the Remote Controller with Other Components Remote Control Codes130 DVD DVD player131 CBL cable receiver132 SEI133 LXIControlling a VCR 134Controlling a Satellite Tuner Remote controller mode for your cable 135Controlling a TV Controlling a Cable ReceiverLearning Commands from Another Remote Controller 136Making Macros Using Macros137 Naming Macros 138Running Macros Other Settings for the Remote Controller Editing Remote Controller ModesAdding New Remote Controller Modes Reordering the Remote Controller ModesOther Settings for the Remote Controller Deleting Remote Controller ModesAssigning Remote Controller Modes 140Resetting the Remote Controller 141Changing the Remote Controller’s Control ID 142Relationship Between Input Source and Listening Mode 143Relationship Between Input Source and Listening Mode 144145 SacdUsing the RDC-7.1 with Option Boards 146USA, Canada, and Australian models only Types of the RDC-7.1 Option Boards147 Installing the Option Boards USA and Australian Models Only 148Troubleshooting Power149 AudioTroubleshooting Remote Controller150 Video151 RecordingZone 2/Zone Net-TuneError Messages Speciﬁcations152 General153 Speciﬁcations USA and Canadian modelsAmpliﬁer Section Tuner Section154 Speciﬁcations Other than USA and Canadian models155 Onkyo Europe Electronics GmbH Onkyo Europe UK Office

Related manuals

Manual 8 pages 10.7 Kb