Integra DTR-4.5 instruction manual Crossover, Double Bass, Buttons to select d. Surround, Default

First Time Setup—Continued

7	Use the Up and Down [ ]/[ ]
	buttons to select “d. Surround,”

and then use the Left and Right

Enter

[]/[ ] buttons to select:

Small: Select if the surround left and right speakers are small.

Large: Select if the surround left and right speakers are large.

None: Select if no surround left and right speakers are connected.

Note:

•If the Front setting in step 5 is set to Small, the Large option cannot be selected.

Continue with step 8.

Crossover

8	Use the Up and Down [ ]/[ ]
	buttons to select “g. Crossover,”

and then use the Left and Right

Enter

[]/[ ] buttons to select a crossover frequency.

Choose a crossover frequency suitable for your setup. If you’re using a sub- woofer, choose a crossover frequency based on the diameter of your front speakers. If you’re not using a sub- woofer, use the diameter of any speaker that you specified as Small.

Speaker cone	Crossover
diameter	frequency
Over 8 in.	60Hz
6-1/2 to 8 in.	80Hz
5-1/4 to 6-1/2 in.	100Hz
3-1/2 to 5-1/4 in.	120Hz
Under 3-1/2 in.	150Hz

Notes:

•If the crossover frequency is set to a low value, and the program material doesn’t contain any sounds below that frequency, the subwoofer will not output much sound.

Double Bass

With the Double Bass function, you can boost bass out- put by feeding bass sounds from the front left and right channels to the subwoofer. This function can be set only if the Subwoofer setting in step 4 is set to Yes, and the Front setting in step 5 is set to Large.

9 Use the Up and Down []/[ ] buttons to select “g. Double Bass,” and then use the Left and

Enter

Right []/[ ] buttons to select: On: Double Bass function on. Off: Double Bass function off

(default).

10	Press the [Setup] button.
	The setup menu closes.

Notes:

•This procedure can also be performed on the AV receiver by using its [Setup] button, arrow buttons, and [Enter] button.

40