Integra DTR-4.5 Basic Operation, Setting the Display Brightness, Muting the AV receiver

Basic Operation—Continued

	CD		Tape		Tuner
	7		8		9
							TV VOL
	+10		0		Clear
	--/---	Input Selector
		Macro
Press	1		2		3		Zone 2
			Remote Mode
[Receiver]	Receiver		DVD		CD		MD/CDR
	Tape
first	TV		VCR		Cable		SAT
Dimmer	Dimmer						Sleep
		o			M	u	Sleep
	TV		enu
		T	pM		en
	Input
	+
	CH				Enter		VOL
	Disc
	-		E		e
				xit
					id
					Gu
	Prev	R	eturn			p	Muting
	CH				Setu
	Display						Muting
	Rec						Random

Setting the Display Brightness

You can adjust the brightness of the display.

Receiver	Press the [Receiver] button, and
	then press the [Dimmer] button
	repeatedly to select Normal, Dim
	or Dimmer.
Dimmer	•	Normal
	•	Dim
	•	Dimmer

Muting the AV receiver

You can temporarily mute the output of the AV receiver.

Press the [Receiver] button, and

Receiver then press the [Muting] button.

The output is muted and the MUTING indicator flashes on the display, as shown.

Muting

To unmute the AV receiver, press the [Muting] button again, or adjust the volume.

The Mute function is cancelled when the AV receiver is set to Standby.

Using the Sleep Timer

With the sleep timer, you can set the AV receiver to auto- matically turn off after a specified period.

Press the [Receiver] button, and

Receiver then press the [Sleep] button

repeatedly to select the required sleep time.

The sleep time can be set from 90 to 10

Sleep

minutes in 10 minute steps.

The SLEEP indicator appears on the display when the sleep timer has been set, as shown. The specified sleep time appears on the display for about five seconds, then the previous display reappears.

If you need to cancel the sleep timer, press the [Sleep] button repeatedly until the SLEEP indicator disappears.

To check the time remaining until the AV receiver sleeps, press the [Sleep] button. Note that if you press the [Sleep] button while the sleep time is being displayed, you’ll shorten the sleep time by 10 minutes.

Using Headphones

You can connect a pair of stereo headphones (1/4-inch phone plug) to the AV receiver’s Phones jack for private listening, as shown.

Zone 2

Standby

Phones

Notes:

•Always turn down the volume before connecting your headphones.

•The speakers are turned off while the headphones plug is inserted in the Phones jack. (Zone 2 speakers are not turned off.)

•When you connect a pair of headphones, the listening mode is set to Stereo, unless it’s already set to Stereo, Mono, or Direct. When you disconnect the head- phones, the previous listening mode is resumed.

•Only the Stereo, Direct, and Mono listening modes can be used with headphones. (The listening modes available also depends on the currently selected input source.)

•When the multichannel input is used, only the front left and right audio can be heard in the headphones.

45