Integra DTR-4.5 instruction manual Speaker Level Calibration, Main menu appears onscreen

First Time Setup—Continued

Speaker Level Calibration

Here you can adjust the level of each speaker with the built-in test tone so that the volume of each speaker is the same at the listening position.

Notes:

•The speakers cannot be calibrated while the output of the AV receiver is muted, while a pair of headphones is connected, or when using the multichannel input.

	CD	Tape	Tuner
	7	8	9
				TV VOL
	+10	0	Clear
	--/---	Input Selector
		Macro
	1	2	3	Zone 2
1		Remote Mode
	Receiver	DVD	CD	MD/CDR
	Tape
	TV	VCR	Cable	SAT
	Dimmer			Sleep

3

Enter

Enter

Use the Up and Down []/[ ] buttons to select “3. Level Cali- bration,” and then press [Enter].

The Level Calibration menu appears and the pink noise test tone is output by the front left speaker.

Menu

------------------------
Basic Setup
2.Speaker Setup	-
1-----------------------.Initial Setup

1.Speaker Config
2-34.LeveEqualizerCalibraSettionngs
2.Speaker Distance------------------------
Use Settings	:Manual
Advanced	:	0dB
3.a.Left
4 b.Center Left	:	0dB
ca.Right80Hz	:	0dB
5.Listening Mode Preset
db.Surr250HzRight	:	0dB
6.Preference
ec.Surr800HzLeft	:	0dB
fd.Subwoofer2.5kHz	:	0dB
e. 8kHz	:	0dB

2, 3	TV		enu		M	en
			pM
	Input	o				u
		T
	+							2–4
	CH				Enter		VOL
	Disc
	-		E			e		1, 6
				xit
					id
					Gu
	Prev	R	eturn			p
	CH				Setu
	Display						Muting
	Rec						Random
1	Press the [Receiver] button fol-
	lowed by the [Setup] button.
Receiver

The main menu appears onscreen.

2	Use the Up and Down [ ]/[ ]
	buttons to select “2. Speaker
Enter	Setup,” and then press [Enter].
	The Speaker Setup menu appears.

Enter

Note:

Speakers that you set to No or None on the Speaker Configuration page (page 39) cannot be selected.

4	Use the Up and Down [ ]/[	]
	buttons to select each speaker,
	and use the Left and Right [	]/

Enter

[ ] buttons to set the volume. The volume can be adjusted from –12 to +12 dB in 1 dB steps (–15 to +12 dB for the subwoofer).

5	Repeat step 4 until the volume of
	the test tone from each speaker
	is the same.
6	Press the [Setup] button.
	The setup menu closes.

Notes:

•This procedure can also be performed by using the remote controller. First press the [Test Tone] button to output the test tone. Use the [Level–] and [Level+] buttons to set the volume, and use the [CH SEL] but- ton to select the speakers.

42