Integra Master Your Remote Control Commands for the DTR 4.5

Controlling Other Components—Continued

Learning Commands from Another Remote Controller

The AV receiver’s remote controller can learn the com- mands of other remote controllers simply by pointing them at each other. For example, by transmitting the Play command from your CD player’s remote controller, the remote controller can learn it and then transmit the same command when its Play [ ] button is pressed in CD mode.

This is convenient when you want to add commands to buttons after entering a remote control code (page 69).

1, 4	On	Standby					T V
					I		Input
	V1		V 2		V 3
	1		2		3		+
		Multi CH			DVD		TV CH
	4		5		6		-
	CD		Tape		Tuner
	7		8		9
							TV VOL
	+10		0		Clear
	--/---	Input Selector
		Macro
	1		2		3		Zone 2
			Remote Mode
1	Receiver		DVD		CD		MD/CDR
	Tape
	TV		VCR		Cable		SAT
Dimmer							Sleep
TV			enu		M
			pM		en
Input		o				u
		T
	+
	CH			Enter			VOL
	Disc
	-		E		e
				xit
					id
					Gu
Prev		R	eturn			p
CH					Setu
Di	l						M ti

1				While holding down the Remote
	Remote Mode			Mode button that you want to
Receiver	DVD	C D	MD/CDR	learn the command, press the
Tape
T V	VCR	Cable	SAT [On] button.
	On

2	On the AV receiver’s remote con-
	troller, press the button you want
	to learn the new command.

3	Point the remote controllers at
	each other, about 2 to 6 inches
	(5–15 cm) apart, and then, on the
	other remote controller, press the
	button whose command you
	want to learn.
	About 2 to 6
	inches (5–15 cm

RC-587M

4	To teach the AV receiver’s remote
	controller more new commands,
	repeat steps 2 and 3.
	Press the [On] button when you’ve fin-
	ished.

Notes:

•The following buttons cannot be taught new com-

mands: Remote Mode, Macro [1], [2], [3], TV [ ],

TV [Input], TV CH [+]/[–], TV VOL []/[ ].

•The AV receiver’s remote controller can learn up to approximately 150 commands. However, the com- mands of some remote controllers may use a lot of memory, in which case, this will be reduced.

•By default, the AV receiver’s remote controller knows the commands for controlling an Integra CD player, cassette deck, DVD player, and MD player (e.g., Play, Stop, Pause, etc., buttons). These buttons can learn new commands, although the defaults will be restored if the remote controller is reset.

•To learn a new command for a button that has already learned one, simply repeat this procedure.

•Like most remote controllers, the AV receiver’s remote controller uses infrared. Commands from remote controllers that don’t use infrared cannot be learnt.

•When the remote controller’s batteries expire, all learned commands will be lost and will have to be learned all over again, so don’t discard your other remote controllers.

77