REPLACING THE LEFT BROOM SKIRT
1.Turn off machine and set parking brake.
FOR SAFETY: Before leaving or servicing machine, stop on level surface, apply parking brake, turn off machine and remove key.
2.Raise rear cover and disconnect the batteries from the machine.
3.Open the left broom door.
NOTE: The left skirt is mounted to the frame. This skirt does not have a wear indicator strip.
4.Remove the five adjustment nuts and the retaining bars.
5.Replace the worn side skirt with a new skirt.
6.Install the retaining bars and adjustment nuts.
7.Adjust the side skirt.
ADJUSTING THE LEFT BROOM SKIRT
1.Turn off machine and set parking brake.
FOR SAFETY: Before leaving or servicing machine, stop on level surface, apply parking brake, turn off machine and remove key.
2.Raise rear cover and disconnect the batteries from the machine.
3.Open the left broom door.
NOTE: The left skirt is mounted to the frame. This skirt does not have a wear indicator strip.
4.Loosen the five adjustment nuts.
5.Adjust the side skirt for correct floor clearance, then tighten the adjustment nuts.
6.Tighten the five broom skirt.
7.Adjust the rear skirt.
MAINTENANCE
ADJUSTING THE REAR BROOM SKIRT
1.Turn off machine and set parking brake.
FOR SAFETY: Before leaving or servicing machine, stop on level surface, apply parking brake, turn off machine and remove key.
2.Loosen the five upper adjustment nuts on the rear skirt mounting plate.
3.Adjust the rear skirt for correct floor clearance, then tighten the adjustment nuts.
RECIRCULATION SKIRT
The recirculation skirt helps to channel debris that has been carried over the main broom, back into the sweeping area. The recirculation skirt should be checked daily for wear or damage.
REPLACING THE RECIRCULATION SKIRT
1.Turn off machine and set parking brake.
FOR SAFETY: Before leaving or servicing machine, stop on level surface, apply parking brake, turn off machine and remove key.
2.Raise the rear cover and disconnect the batteries from the machine.
3.Remove the main broom.
4.Open the left broom door.
5.Remove the three retaining nuts and retaining strip on the left side broom skirt.
6.Loosen the five retaining nuts on the recirculating skirt retaining plate.
7.Slide the worn skirt out of the skirt retainer and replace with a new skirt.
8.Hold the skirt firmly in place and tighten the five retaining bolts. No adjustment is required.
QTFSG/QTFSD 98349 05/15/03 | |
|