Windsor QTFSG, QTFSD manual Controls, Special Notes

Page 10

CONTROLS

SPECIAL NOTES:

The sound pressure level at the operator’s ear was measured to be 78 dBA for the QTFSG and 83 dBA for the QTFSD. This was a nearfield, broad-band measurement made during normal operation on a composite tile floor with a white pad. This appliance contains no possible source of impact noise. The instantaneous sound pressure level is below 63 Pa.

The weighted root mean square acceleration at the operator’s arms was measured to be below 2.5m/s2 for the QTFSG and below 3.2m/s2 for the QTFSD. The weighted root mean square acceleration at the operator’s posterior was measured to be below 0.5m/s2 for the QTFSG and below 1.3m/s2 for the QTFSD. This was a tri-axial, third-octave-band measurement made during normal operation on a composite tile floor. The measurement and related calculations were made in accordance with ANSI S3.34-1986.

3-2

QTFSG/QTFSD 98349 05/15/03

 

Image 10
Contents Floor Sweeper Model Tracer FSYour Dealer Machine Data LOGOverview Table of Contents HOW to USE this Manual ModelImportant Safety Instructions Read ALL Instructions Before Using this MachineHazard Intensity Level Hazard Intensity LevelSafety Label Location Safety Label Location Technical Specifications DIMENSION/CAPACITYControls Special NotesControls Brake Pedal Filter Shaker SwitchDirectional Control Pedal Parking Brake LeverHopper Safety ARM Hopper Door SwitchHopper Lift Switch Engine Temperature LightCircuit Breakers KEY SwitchChoke GAS only Horn PADStarting the Machine OperationsBefore Operating the FS To SweepStoring the Machine To Engage the Hopper Safety ARMStopping the Machine Dumping the HopperMachine Jacking To Disengage the Hopper Safety ARMTowing or Pushing Machine To Jack UP MachineHydraulic Fluid Reservoir MaintenanceHydraulic Fluid Hydraulic PumpDirectional Control System Hydraulic FilterRefer to the Electrical Control Group in the Parts section To Install the Main Broom To Remove the Main BroomMain Broom Adjustment Knob Checking and Adjusting the Main Broom PatternMain Broom Pattern To 1-1/2 25.4 to 38.1mm Raised hopper may fall. Engage hopper safety arm To Install the Side BroomAdjusting the Side Broom To Remove the Side BroomTo Replace Belt Adjusting the Jackshaft BeltTransmission Jackshaft Belt Transmission BeltReplacing and Adjusting the Vacuum Impeller Belt Replacing and Adjusting Main Broom BeltTo Align Belt To Realign Replacing and Adjusting DifferentialImpeller Belt Drive ChainAdjusting the Right Broom Door Skirt Replacing and Adjusting the Drive Wheel ChainsReplacing the Right Broom Door Skirt Replacing the Left Broom Skirt Adjusting the Left Broom SkirtAdjusting the Rear Broom Skirt Recirculation SkirtReplacing the Hopper Seals Adjusting the Hopper Side SealsHopper Seals Hopper LIP SkirtsHopper Hopper Door SealsReplacing Door Seals Hopper Dust FilterAIR To Adjust the BrakesRaised hopper arm may fall. Engage hopper safety arm Brakes Refer to the Brake Group in the Parts sectionBattery Battery MaintenanceHopper will not lift Hydraulic Schematic Hydraulic TroubleshootingProblem Cause Solution Hopper will not lowerPressing foot pedal No propellingMachine moves without Full speed onlyPoor sweeping Machine TroubleshootingExcessive dusting Machine travels slowlyService Schedule Maintenance Daily Weekly 50HRS