Getting Started | Hearth and Home Technologies COLBAY-FS-B instruction

2 Getting Started

A. Design & Installation Considerations

Quadra-Fire direct vent gas appliances are designed to operate with all combustion air siphoned from outside of the building and all exhaust gases expelled to the outside. No additional air source is required.

CAUTION

Check building codes prior to installation.

•Installation MUST comply with local, regional, state and national codes and regulations.

•Consult local building, ﬁre ofﬁcials or authorities having jurisdiction about restrictions, installation inspection, and permits.

When planning an installation, it is necessary to determine the following information before installing:

•Where the appliance is to be installed.

•The vent system conﬁguration to be used.

•Gas supply piping.

•Electrical wiring.

•Whether optional accessories - devices such as a blower, thermostat or remote control - are desired.

C. Inspect Appliance & Components

WARNING

Inspect appliance and components for damage. Damaged parts may impair safe operation.

•Do NOT install damaged components.

•Do NOT install incomplete components.

• Do NOT install substitute components.

Report damaged parts to dealer.

•Carefully remove the appliance and components from the packaging.

•Remove cast door and glass door, and set aside on pro- tective surface.

•Remove log set and component pack from ﬁrebox.

•Report to your dealer any parts damaged in shipment, particularly the condition of the glass.

•Read all of the instructions before starting the instal- lation. Follow these instructions carefully during the installation to ensure maximum safety and beneﬁt.

WARNING

Keep appliance dry.

•Mold or rust may cause odors.

•Water may damage controls.

B.Tools and Supplies Needed

Before beginning the installation be sure that the following tools and building supplies are available. Note: Not all

tools will apply to every installation.

Reciprocating saw	Variable Speed Drill/Driver
Pliers	Wrench Set
Hammer	Framing Square
Phillips Screwdriver	Framing Material
Flat Blade Screwdriver	Hi temp caulking material
Plumb Line	Voltmeter
Level	Gloves
Manometer	Safety Glasses
Tape Measure	Non-corrosive Leak Check Solution
	or combustible gas detector

WARNING

Hearth & Home Technologies disclaims any responsibility for, and the warranty will be voided by, the following actions:

•Installation and use of any damaged appliance or vent system component.

•Modiﬁcation of the appliance or vent system.

•Installation other than as instructed by Hearth & Home Technologies.

•Improper positioning of the gas logs or the glass door.

•Installation and/or use of any component part not approved by Hearth & Home Technologies.

Any such action may cause a ﬁre hazard.

Page 6

Quadra-Fire • Columbia Bay • 250-5195 Rev. K

10/08