Hearth and Home Technologies 6000TRSI-AUC, Heat & Glo manual Ignition System Wiring, Shock Risk

Page 19

E. IGNITION SYSTEM WIRING

•This gas fireplace is equipped with an electronic igni- tion system which operates on a 6 volt system.

•This appliance requires 240 VAC to be wired to the factory installed junction box. Check factory installed power cord for damage before using.

CAUTION

Label all wires prior to disconnection when servic- ing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing.

WARNING

Shock Risk

•Replace damaged wire with type 105O C rated wire.

•Wire must have high temperature insulation.

FLAME SPARKER/
SENSOR	VALVE
	REMOTE
	CONTROL
	ANT.
	ON/OFF
PILOT	WALL SWITCH
	IGNITION
IGNITION MODULE	MODULE
IGNITION MODULE	(6V)
6VDC	(6V)
6VDC
	GROUND
NEUTRAL		HOT
BATTERY PORT
		PLUG IN
ON/OFF	THERMOCOUPLE
ON/OFF	BLOCK
SWITCH	(CONNECTED TO
	BACK OF VALVE)
	VALVE
GAS LINE
CONNECTED TO
BACK OF VALVE
FIGURE 1.29
Heat & Glo • 6000TRSI-AUC • 2078-900 Rev. G • 12/06		19

Image 19

Contents Model 6000TRSI-AUC Installation and Operation InstructionsHeat & Glo Quality Systems Table of Contents 476 686 31-5/8 803 174 126.9 Installation InstructionsTop Flue Rear FlueClearance Requirements Framing the Heater Clearances n mm 10.97m Flue System Approvals and InstallationsElbows 13.1 331mm 24 610mmFlueing with One 90 Elbow +H 1 FT + H 1 FT 13 Flueing with three 90 elbows + H 1 FT Flueing with Three 3 90 ElbowsFlueing Out the Top Flue Flueing Out the Rear FlueAssembling Flue Components Install Support Brackets Flue Termination Must be Positioned SO That the Arrow is Pointing UP Connecting the GAS SupplyShock Risk Ignition System WiringBlower Fan Clearance to a mantelpiece is 12 inches 305mm. See Figure Mantel ClearancesTabs LOG Placement InstructionsHeat & Glo 6000TRSI-AUC 2078-900 Rev. G 12/06 Operating Instructions Installer TestingOperating Cautions Safety & Lighting Information For Your Safety Read Before Lighting InstructionsFAN Operation Power OutageServicing and Maintenance Removal of Covers for Servicing Removal of Components for ServiceParts Replacement Adjustments and Replacement PartsInspect Maintenance Tasks Maintenance TasksElectronic Ignition System TroubleshootingAdjust the air shutter at the base of the burner 6000TRSI-AUC Log set assemblyGLA-6TRXI 6000TRSI-AUCHeat & GLO, a brand of Hearth & Home Technologies Inc Limited 10 Year WarrantyMelbourne