Hearth and Home Technologies Heat & Glo manual Adjust the air shutter at the base of the burner

Page 32

Electronic Ignition System - (continued)

Symptom	Possible Causes	Corrective Actions
10. Glass soots.	a. Flame impingement on	Adjust the log set so that the flame does not impinge on it.
	logs.

	b. Improper venturi setting.	Adjust the air shutter at the base of the burner.

	c. Debris around venturi.	Inspect the opening at the base of the burner. It is imperative that NO
		material be placed in this opening.

11. Flame burns blue	a. Insufficient oxygen	1. Check to make sure flue cap is installed properly and free of debris.
and lifts off burner.	being supplied.	Make sure that flue system points are tight and have no leaks.
		2. Check to make sure that no material has been placed in the opening at
		the burner base or in the area of the air holes in the center of the base
		pan beneath the burne.
		3. Be sure glass is tighened properly on unit, particularly on top corners.

32	Heat & Glo • 6000TRSI-AUC • 2078-900 Rev. G • 12/06

Image 32

Contents Installation and Operation Instructions Model 6000TRSI-AUCHeat & Glo Quality Systems Table of Contents Installation Instructions 476 686 31-5/8 803 174 126.9Clearance Requirements Rear FlueTop Flue Framing the Heater Clearances n mm Flue System Approvals and Installations 10.97m13.1 331mm 24 610mm ElbowsFlueing with One 90 Elbow +H 1 FT + H 1 FT 13 Flueing with three 90 elbows Flueing with Three 3 90 Elbows + H 1 FTFlueing Out the Rear Flue Flueing Out the Top FlueAssembling Flue Components Install Support Brackets Flue Termination Connecting the GAS Supply Must be Positioned SO That the Arrow is Pointing UPIgnition System Wiring Shock RiskBlower Fan Mantel Clearances Clearance to a mantelpiece is 12 inches 305mm. See FigureLOG Placement Instructions TabsHeat & Glo 6000TRSI-AUC 2078-900 Rev. G 12/06 Installer Testing Operating InstructionsOperating Cautions For Your Safety Read Before Lighting Instructions Safety & Lighting InformationPower Outage FAN OperationServicing and Maintenance Removal of Components for Service Parts ReplacementAdjustments and Replacement Parts Removal of Covers for ServicingMaintenance Tasks Inspect Maintenance TasksTroubleshooting Electronic Ignition SystemAdjust the air shutter at the base of the burner Log set assembly 6000TRSI-AUC6000TRSI-AUC GLA-6TRXILimited 10 Year Warranty Heat & GLO, a brand of Hearth & Home Technologies IncMelbourne