Emerson Process Management 9110-00A, Series 9110 Analog Input Models, RAISE/LOWER Input Models

3.1.1 Switch Functions

The Regulator assembly is configured by two, eight-switch packages which perform the functions listed in Table 3-1.

Table 3-1 - Regulator Assembly Switch SW1 & SW2 Functions & Settings

Switch	Switch	Page	*	**
Label	Function	Ref.	Your Setting	Your Notes
SW1-1	R/L % per pulse increment	3-4
SW1-2	R/L % per pulse increment	3-4
SW1-3	R/L % per pulse increment	3-4
SW1-4	R/L % per pulse increment	3-4
SW1-5	R/L % per pulse increment	3-4
SW1-6	Not Used	None
SW1-7	Not Used	None
SW1-8	Input Filter	3-4
SW2-1	Guard (Dynamic/Static)	3-5
SW2-2	Actuator Output Rate of Change	3-6
SW2-3	Actuator Output Rate of Change	3-6
SW2-4	Actuator Output Rate of Change	3-6
SW2-5	Actuator Output Rate of Change	3-6
SW2-6	Guard (Active/Inactive)	3-5
SW2-7	Not Used	None
SW2-8	Analog Input (V or I)	3-2

*Record your switch settings (ON or OFF) here for future reference.

**List your corresponding switch functions or values here.

3.2 ANALOG INPUT MODELS

Initially, it will be necessary to check the position of switches SW1-1 through SW1-5. These switches must be set to their OPEN positions to properly disable the functions associated with Raise/Lower models. The other uses of these switches are described under topic 3.3.

Analog models can be set to accept a 4-20 mA or 1-5 V dc signal at the Command Input. Switch SW2-8 selects these outputs as follows:

SW2-8	Analog Range
Close	4-20 mA dc
Open	1-5 V dc

3.3 RAISE/LOWER INPUT MODELS

Raise/Lower Actuator models can be set for continuous or incremental-type input signals via switches SW1-1 through SW1-5. The switch positions are shown in Table 3-2. The switch selections are described as follows:

Board Setup 3-2 CI-9110