Hearth and Home Technologies 31M-ACC-MBK, 31ST-ACC Wood Stove Series ACC Step-Top Uni-Body Model

R

3100 Wood Stove Series (ACC)

Step-Top Uni-Body Model

For the Step Top Pedestal Model In US installations, it is necessary to install a floor protector of a minimum of 3/8 inch (9.5mm) thick metal clad millboard or equivalent a minimum of 16 inches (406mm) in front of glass and 8 inches (203mm) to both sides of the fuel loading door. Open the door and measure 8 inches (203mm) from the side edge of the open- ing in the face of the appliance. *See page 12 for Canadian clearances and horizontal venting exception.

For the Step Top Leg Model In US installations, it is nec- essary to install a floor protector of a minimum thickness of 1-1/4 inch (32mm) or 1/2 inch of “k” value of 0.84 thick metal clad millboard or equivalent a minimum of 16 inches (406mm) in front of glass and 8 inches (203mm) to both sides of the fuel loading door. Open the door and measure 8 inches (203mm) from the side edge of the opening in the face of the appliance. *See page 12 for Canadian clearances and horizontal venting exception.

4-3/4 in.	3-1/4 in.
	9-5/8 in.
Fuel loading door	minimum

16 in. from glass 8 in.

1-5/8 in. minimum

USA

Figure 13.1

			48-9/16 in.
		.	optional
-5/8		in
31
			coverage		29-1/4 in.
			135°
		.		.	.
					in
	in			in
-15/16			-5/16	-1/16
				3
38			27
					USA

Figure 13.3

	20mm (8 in.)
20mm	20mm
(8 in.)	(8 in.)
	1254mm
	(49-/8 in.)
	minimum

457mm (18 in.)

1041mm (41 in.)

minimumCANADA

Figure 13.2

USA required

Canada recommended

Must extend 2 in. (51mm) beyond each side of pipe (shaded area)

Figure 13.4

NOTE: • Illustrations and photos reflect typical installations and are FOR DESIGN PURPOSES ONLY.

•Illustrations/diagrams are not drawn to scale.

•Actual installation may vary due to individual design preference

•Hearth & Home Technologies reserves the right to alter its products.

September 1, 2008 7033-277F Page 13