Hearth and Home Technologies 31M-ACC-MBK, 31ST-ACC Wood Stove Series ACC Glass Replacement

Page 33

R

3100 Wood Stove Series (ACC)

B. Glass Replacement

1.Ensure that the fire is out and the appliance is cool to the touch.

2.Protect a table or counter top with padding or towels. Protect your hands and wear gloves to prevent injury.

3.Remove the door with the broken glass by lifting the door up and off of the hinges.

4.Lay door face down on a table or counter making sure the handle hangs over the edge so the door lays flat, on a soft surface.

5.Remove the screws from each glass retainer and remove the glass. (If screws are difficult to remove, soak with penetrating oil first).

6.Center the glass with edges evenly overlapping the opening in the door, (i.e. same space top and bottom, left and right sides).

7.Replace the glass retainers. Be careful not to cross thread the screws.

8.Tighten each retainer just a few turns until each is secured. Check again for centering of glass in door frame. Continue to tighten each retainer alternately, a few turns at a time, until the glass is secure. DO NOT OVERTIGHTEN.

9.Replace the door on the appliance.

Quadra-Fire stoves are equipped with ceramic super heat-resistant glass, which can only be broken by impact or misuse. Do not slam stove door or impact the glass. When closing door, make sure that logs do not protrude against the glass. Inspect glass regularly. If you find a crack or break, immediately put the fire out and return the door to your dealer for replacement of glass before further use.

WARNING

Glass

Assembly

Handle glass with care.

•Inspect the gasket to ensure it is undamaged.

•Do NOT strike, slam or scratch glass.

•Do NOT operate appliance with glass & door assembly removed.

•Do NOT operate with glass cracked, broken or scratched.

WARNING

Fire Risk.

Injury Risk.

•Use only glass specified in manual.

•DO NOT REPLACE with any other material. Glass breakage will occur.

September 1, 2008

7033-277F

Page 33

Image 33

Contents Hot glass will cause burns Step Top Uni-Body Model Millennium Model7033-277F September 1007 Wood Stove Series ACCSerial No Model Name Mfg. Date 7033-277F September 1Table of Contents Glass Specifications Appliance Certification BTU & Efficiency SpecificationsListing and Code Approvals Mobile Home ApprovedGetting Started Fire Safety7033-277F September 1 Wood Stove Series ACC Negative PressureVenting Systems Wood Stove Series ACC Flue Draft ConsiderationsTools And Supplies Needed Inspect Appliance & Components and Pre-Use Check ListMasonry Chimney Wood Stove Series ACC Typical Stove SystemsDimensions and Clearances Appliance DimensionsMillennium Model 11/16 in mm 11/16 in mm 89mm Back of Stove to Glass10-/8 in mm 21-1/8 in 7mm 7033-277F September 1 Double Wall Pipe Wood Stove Series ACC Clearances to Combustibles UL and ULC31004Wood Stove Series ACC InstallationHearth Protection Requirements Millennium ModelWood Stove Series ACC Step-Top Uni-Body Model Wood Stove Series ACC Outside Air Kit Installation Items Needed for Installation not suppliedFire Risk Asphyxiation Risk Shock Risk Wood Stove Series ACC Blower OptionalChimney Requirements Chimney ConnectorVenting Components Chimney Systems ThimbleAir Clearances ComponentsInstructions Solid Pack Chimney with Metal Supports as a ThimbleInstalling Chimney Components Solid Pack Chimney with Metal Supports as a Thimble Cont’dChimney Height / Rise and Run Rule Wood Stove Series ACC Chimney Termination RequirementsPitched Roof Flat RoofMobile Home Installation Begin installing the ARS System Appliance Set UpFinishing the ARS Installation Installing Pedestal AssemblyCorners. Figure Installing Leg KitAdjusting The Blower Speed Control Wood Stove Series ACC Door Handle AssemblyOver-Firing Your Appliance Wood Selection & Storage Cont’d Operating InstructionsWood Selection & Storage Burning ProcessAir Controls Automatic Combustion Control ACCBurn Rates and Operating Efficiency Wood Stove Series ACC Building a Fire Incorrect Positions Wood Stove Series ACC Correct Baffle & Blanket PlacementInitial cold start-up and all Burn Settings Frequently Asked Questions Opacity SmokeWood Stove Series ACC Blower Operating Instructions Snap Disc LocationAsh Removal System ARS Operating and Cleaning General MaintenanceCreosote Chimney Cleaning Maintaining & Servicing Your ApplianceCleaning Plated Surfaces Glass Cleaning Frequency As desiredWhen cleaning glass Disposal of AshesWood Stove Series ACC Glass Replacement Appliance without firebrick Wood Stove Series ACC Firebrick ReplacementTo your authorized dealer Brick Size QtySnap Disc Location Wood Stove Series ACC Baffle Removal Snap Disc ReplacementWood Stove Series ACC Tube Channel Assembly Replacement Removing Tube Channel AssemblyReplacing Tube Channel Assembly Start Fire Problems Possible Cause Solution TroubleshootingExploded view Reference Materials#29 Ceramic Blanket 19 w x 13-3/4 h, 1/2 thick #33 Baffle Board 2 w x 13-3/4 h, eachFlue Collar can’t replace in the field Step-Top Uni-Body ModelBlower Assembly Wood Stove Series ACC Service Parts & AccessoriesItem # Service Parts Item # Service Parts Date of Service Performed By Description of Service Wood Stove Series ACC Service And Maintenance LogWood Stove Series ACC Homeowner’s Notes CONDITIONS, Exclusions & Limitation of Liability September 1 7033-277F Contact Information