Hearth and Home Technologies 31ST-ACC, 31M-ACC-MBK owner manual Installing Pedestal Assembly

Page 22

3100 Wood Stove Series (ACC)

R

	Pedestal and Ash Removal System (Cont’d)
	Installing Pedestal Assembly
	1.	Remove screws on adapter and slide pedestal over
		adapter on bottom of stove. Figure 22.1.
	2.	Line up holes in sides of pedestal with holes in adapter.
	3.	Securely tighten pedestal into place.		Grate
	4.	Carefully stand stove up and place in desired location.		ARS
	5.	Slip wooden decorative strips onto pedestal edges.		ARS
	5.	Slip wooden decorative strips onto pedestal edges.		Channel
	Finishing the ARS Installation
	1.	Re-install the ARS channel that was removed in Step 3 on
		page one and secure with 2 bolts previously removed.
		Set the grate into the ARS channel	Replace the 2	Replace both bricks
		front cut bricks. Figure 22.2.		Replace both bricks
		front cut bricks. Figure 22.2.		back into firebox
	2.	Install the ash drawer.		back into firebox
	2.	Install the ash drawer.
	3.	Check to make sure baffle boards and ceramic blanket are
		in their proper locations. (see page 29).		Figure 22.2

NOTE: If installing a floor installation of an outside air kit on a Step Top model with a pedestal assembly you must attach the enclosed cover plate to the back of the stove. Other wise you may discard this piece. Figure 22.3.

Adapters

Cover

Plate

Ash Removel

Drawer

Figure 22.3

Oak

Pedestal

Trim

Figure 22.1

Page 22

7033-277F

September 1, 2008

Image 22

Contents 7033-277F Step Top Uni-Body Model Millennium ModelHot glass will cause burns September 1Serial No Model Name Wood Stove Series ACC007 Mfg. Date 7033-277F September 1Table of Contents Listing and Code Approvals Appliance Certification BTU & Efficiency SpecificationsGlass Specifications Mobile Home ApprovedFire Safety Getting StartedWood Stove Series ACC Negative Pressure 7033-277F September 1Tools And Supplies Needed Wood Stove Series ACC Flue Draft ConsiderationsVenting Systems Inspect Appliance & Components and Pre-Use Check ListWood Stove Series ACC Typical Stove Systems Masonry ChimneyAppliance Dimensions Dimensions and ClearancesMillennium Model 11/16 in mm 89mm Back of Stove to Glass 11/16 in mm10-/8 in mm 21-1/8 in 7mm 7033-277F September 1 Wood Stove Series ACC Clearances to Combustibles UL and ULC Double Wall PipeHearth Protection Requirements Installation31004Wood Stove Series ACC Millennium ModelWood Stove Series ACC Step-Top Uni-Body Model Items Needed for Installation not supplied Wood Stove Series ACC Outside Air Kit InstallationFire Risk Asphyxiation Risk Wood Stove Series ACC Blower Optional Shock RiskVenting Components Chimney Systems Chimney ConnectorChimney Requirements ThimbleInstructions ComponentsAir Clearances Solid Pack Chimney with Metal Supports as a ThimbleSolid Pack Chimney with Metal Supports as a Thimble Cont’d Installing Chimney ComponentsChimney Height / Rise and Run Pitched Roof Wood Stove Series ACC Chimney Termination RequirementsRule Flat RoofMobile Home Installation Appliance Set Up Begin installing the ARS SystemInstalling Pedestal Assembly Finishing the ARS InstallationInstalling Leg Kit Corners. FigureWood Stove Series ACC Door Handle Assembly Adjusting The Blower Speed ControlWood Selection & Storage Operating InstructionsOver-Firing Your Appliance Wood Selection & Storage Cont’d Burning ProcessAutomatic Combustion Control ACC Air ControlsBurn Rates and Operating Efficiency Wood Stove Series ACC Building a Fire Wood Stove Series ACC Correct Baffle & Blanket Placement Incorrect PositionsWood Stove Series ACC Blower Operating Instructions Frequently Asked Questions Opacity SmokeInitial cold start-up and all Burn Settings Snap Disc LocationCreosote Chimney Cleaning General MaintenanceAsh Removal System ARS Operating and Cleaning Maintaining & Servicing Your ApplianceWhen cleaning glass Glass Cleaning Frequency As desiredCleaning Plated Surfaces Disposal of AshesWood Stove Series ACC Glass Replacement To your authorized dealer Wood Stove Series ACC Firebrick ReplacementAppliance without firebrick Brick Size QtyWood Stove Series ACC Baffle Removal Snap Disc Replacement Snap Disc LocationRemoving Tube Channel Assembly Wood Stove Series ACC Tube Channel Assembly ReplacementReplacing Tube Channel Assembly Troubleshooting Start Fire Problems Possible Cause SolutionReference Materials Exploded view#33 Baffle Board 2 w x 13-3/4 h, each #29 Ceramic Blanket 19 w x 13-3/4 h, 1/2 thickStep-Top Uni-Body Model Flue Collar can’t replace in the fieldWood Stove Series ACC Service Parts & Accessories Blower AssemblyItem # Service Parts Item # Service Parts Wood Stove Series ACC Service And Maintenance Log Date of Service Performed By Description of ServiceWood Stove Series ACC Homeowner’s Notes CONDITIONS, Exclusions & Limitation of Liability September 1 7033-277F Contact Information