Hearth and Home Technologies 31M-ACC-MBK, 31ST-ACC owner manual Snap Disc Location

Page 35

R

3100 Wood Stove Series (ACC)

D. Baffle Removal

E. Snap Disc Replacement

1.Remove all ash from the firebox, and extinguish all hot embers before disposal into a metal container.

2.The baffle board has 2 pieces. With the ceramic blanket still in place, slide one baffle piece over the top of other one and pull out top piece through the door opening and then remove bottom baffle piece. Figure 35.1

3.Remove the ceramic blanket.

4.Re-install the baffle pieces one piece at a time. Be sure the baffle boards are even with the front manifold tube and is resting on all tubes. See page 29.

5.To re-install the ceramic blanket, it is easier to fold it in half first. Place on top of baffle board, open up and flatten and smooth out the blanket. Re-check the baffle board for correct positioning. Figure 35.2.

1.Locate the snap disc bracket assembly at the bottom left rear corner of the stove. Figure 35. 3

2.A magnet holds the bracket to the stove. Pull the bracket down away from the stove to expose the snap disc.

3.Pull the snap disc and spade connectors up and out of bracket as shown in Figure 35.4.

4.Using a Phillips head screw driver, remove the 2 screws from the snap disc and then remove the snap disc from the spade connectors. Replace with new snap disc and re-connect to spade connectors.

5.Push the snap disc and spade connectors back inside bracket and re-attach the bracket to the stove.

Figure 35.1 - Baffle

Snap Disc Location

Figure 35.3

Figure 35.2 - Ceramic Blanket

Snap Disc

Magnet

Spade

Connectors

Figure 354.4

September 1, 2008

7033-277F

Page 35

Image 35

Contents September 1 Step Top Uni-Body Model Millennium ModelHot glass will cause burns 7033-277FMfg. Date 7033-277F September 1 Wood Stove Series ACC007 Serial No Model NameTable of Contents Mobile Home Approved Appliance Certification BTU & Efficiency SpecificationsGlass Specifications Listing and Code ApprovalsGetting Started Fire Safety7033-277F September 1 Wood Stove Series ACC Negative PressureInspect Appliance & Components and Pre-Use Check List Wood Stove Series ACC Flue Draft ConsiderationsVenting Systems Tools And Supplies NeededMasonry Chimney Wood Stove Series ACC Typical Stove SystemsMillennium Model Dimensions and ClearancesAppliance Dimensions 10-/8 in mm 21-1/8 in 7mm 7033-277F September 1 11/16 in mm11/16 in mm 89mm Back of Stove to Glass Double Wall Pipe Wood Stove Series ACC Clearances to Combustibles UL and ULCMillennium Model Installation31004Wood Stove Series ACC Hearth Protection RequirementsWood Stove Series ACC Step-Top Uni-Body Model Fire Risk Asphyxiation Risk Wood Stove Series ACC Outside Air Kit InstallationItems Needed for Installation not supplied Shock Risk Wood Stove Series ACC Blower OptionalThimble Chimney ConnectorChimney Requirements Venting Components Chimney SystemsSolid Pack Chimney with Metal Supports as a Thimble ComponentsAir Clearances InstructionsChimney Height / Rise and Run Installing Chimney ComponentsSolid Pack Chimney with Metal Supports as a Thimble Cont’d Flat Roof Wood Stove Series ACC Chimney Termination RequirementsRule Pitched RoofMobile Home Installation Begin installing the ARS System Appliance Set UpFinishing the ARS Installation Installing Pedestal AssemblyCorners. Figure Installing Leg KitAdjusting The Blower Speed Control Wood Stove Series ACC Door Handle AssemblyBurning Process Operating InstructionsOver-Firing Your Appliance Wood Selection & Storage Cont’d Wood Selection & StorageAir Controls Automatic Combustion Control ACCBurn Rates and Operating Efficiency Wood Stove Series ACC Building a Fire Incorrect Positions Wood Stove Series ACC Correct Baffle & Blanket PlacementSnap Disc Location Frequently Asked Questions Opacity SmokeInitial cold start-up and all Burn Settings Wood Stove Series ACC Blower Operating InstructionsMaintaining & Servicing Your Appliance General MaintenanceAsh Removal System ARS Operating and Cleaning Creosote Chimney CleaningDisposal of Ashes Glass Cleaning Frequency As desiredCleaning Plated Surfaces When cleaning glassWood Stove Series ACC Glass Replacement Brick Size Qty Wood Stove Series ACC Firebrick ReplacementAppliance without firebrick To your authorized dealerSnap Disc Location Wood Stove Series ACC Baffle Removal Snap Disc ReplacementReplacing Tube Channel Assembly Wood Stove Series ACC Tube Channel Assembly ReplacementRemoving Tube Channel Assembly Start Fire Problems Possible Cause Solution TroubleshootingExploded view Reference Materials#29 Ceramic Blanket 19 w x 13-3/4 h, 1/2 thick #33 Baffle Board 2 w x 13-3/4 h, eachFlue Collar can’t replace in the field Step-Top Uni-Body ModelBlower Assembly Wood Stove Series ACC Service Parts & AccessoriesItem # Service Parts Item # Service Parts Date of Service Performed By Description of Service Wood Stove Series ACC Service And Maintenance LogWood Stove Series ACC Homeowner’s Notes CONDITIONS, Exclusions & Limitation of Liability September 1 7033-277F Contact Information