Hearth and Home Technologies 31ST-ACC Wood Stove Series ACC Tube Channel Assembly Replacement

Page 36

3100 Wood Stove Series (ACC)

R

F. Tube Channel Assembly Replacement

Removing Tube Channel Assembly

1.Remove the right side shield by removing 2 screws in the back using a Phillips head screw driver.

2.Remove 4 screws from channel access cover and remove cover.

3.Locate 2 channel nuts inside of chamber and remove using a 7/16 socket wrench. Slide out tube channel assembly.

NOTE: Service Space

In order to replace the tube channel assembly a clearance of 19 inches (483mm) is required on the right side of stove in order to remove the tubes with the stove in place.

If space is not available, the stove will have to be discon- nected from the chimney to proceed with the tube replace- ment.

NOTE: Soak the bolts with penetrating oil for at least 15 minutes before trying to remove them.

Replacing Tube Channel Assembly

1.Slide one gasket onto each tube.

2.Slide the tube channel assembly into side of firebox and insert each tube into the corresponding hole in the tube channel rack starting with the back hole first.

3.Make sure tube channel assembly is flush against the side of the stove and secure with channel nuts.

4.Re-install channel cover and side shield.

		Slide one gasket
		over each tube
	Tube Channel Rack	Channel	Channel Cover
	Tube Channel Rack	Access	Channel Cover
		Access	Screws (4)
		Cover	Screws (4)
		Cover

Remove

2 Screws

Channel

Nuts (2)

Tube Channel

Assembly

Figure 36.1

Side Panel

Page 36

7033-277F

September 1, 2008

Image 36

Contents Step Top Uni-Body Model Millennium Model Hot glass will cause burns7033-277F September 1Wood Stove Series ACC 007Serial No Model Name Mfg. Date 7033-277F September 1Table of Contents Appliance Certification BTU & Efficiency Specifications Glass SpecificationsListing and Code Approvals Mobile Home ApprovedFire Safety Getting StartedWood Stove Series ACC Negative Pressure 7033-277F September 1Wood Stove Series ACC Flue Draft Considerations Venting SystemsTools And Supplies Needed Inspect Appliance & Components and Pre-Use Check ListWood Stove Series ACC Typical Stove Systems Masonry ChimneyDimensions and Clearances Appliance DimensionsMillennium Model 11/16 in mm 11/16 in mm 89mm Back of Stove to Glass10-/8 in mm 21-1/8 in 7mm 7033-277F September 1 Wood Stove Series ACC Clearances to Combustibles UL and ULC Double Wall PipeInstallation 31004Wood Stove Series ACCHearth Protection Requirements Millennium ModelWood Stove Series ACC Step-Top Uni-Body Model Wood Stove Series ACC Outside Air Kit Installation Items Needed for Installation not suppliedFire Risk Asphyxiation Risk Wood Stove Series ACC Blower Optional Shock RiskChimney Connector Chimney RequirementsVenting Components Chimney Systems ThimbleComponents Air ClearancesInstructions Solid Pack Chimney with Metal Supports as a ThimbleInstalling Chimney Components Solid Pack Chimney with Metal Supports as a Thimble Cont’dChimney Height / Rise and Run Wood Stove Series ACC Chimney Termination Requirements RulePitched Roof Flat RoofMobile Home Installation Appliance Set Up Begin installing the ARS SystemInstalling Pedestal Assembly Finishing the ARS InstallationInstalling Leg Kit Corners. FigureWood Stove Series ACC Door Handle Assembly Adjusting The Blower Speed ControlOperating Instructions Over-Firing Your Appliance Wood Selection & Storage Cont’dWood Selection & Storage Burning ProcessAutomatic Combustion Control ACC Air ControlsBurn Rates and Operating Efficiency Wood Stove Series ACC Building a Fire Wood Stove Series ACC Correct Baffle & Blanket Placement Incorrect PositionsFrequently Asked Questions Opacity Smoke Initial cold start-up and all Burn SettingsWood Stove Series ACC Blower Operating Instructions Snap Disc LocationGeneral Maintenance Ash Removal System ARS Operating and CleaningCreosote Chimney Cleaning Maintaining & Servicing Your ApplianceGlass Cleaning Frequency As desired Cleaning Plated SurfacesWhen cleaning glass Disposal of AshesWood Stove Series ACC Glass Replacement Wood Stove Series ACC Firebrick Replacement Appliance without firebrickTo your authorized dealer Brick Size QtyWood Stove Series ACC Baffle Removal Snap Disc Replacement Snap Disc LocationWood Stove Series ACC Tube Channel Assembly Replacement Removing Tube Channel AssemblyReplacing Tube Channel Assembly Troubleshooting Start Fire Problems Possible Cause SolutionReference Materials Exploded view#33 Baffle Board 2 w x 13-3/4 h, each #29 Ceramic Blanket 19 w x 13-3/4 h, 1/2 thickStep-Top Uni-Body Model Flue Collar can’t replace in the fieldWood Stove Series ACC Service Parts & Accessories Blower AssemblyItem # Service Parts Item # Service Parts Wood Stove Series ACC Service And Maintenance Log Date of Service Performed By Description of ServiceWood Stove Series ACC Homeowner’s Notes CONDITIONS, Exclusions & Limitation of Liability September 1 7033-277F Contact Information