Kenmore 385.15512 Free-arm Sewing, Changing Needle, For free-arm sewing, For flat-bed sewing

Free-arm Sewing

o For free-arm sewing:

1_Grip the extension table with your index finger and thumb 2. Pull gently to the left The extension table will snap out

•For flat-bed sewing:

1.Insert the tab and the pin into their catche&

2. With your thumb and index finger, gently snap in,

Changing Needle

(D Needle clamp screw (_) Needle clamp

[]	Turn off the power switch
	Raise the needle to its highest position by turning the
	handwheel counterclockwise, toward you, and lower the
	presser fool
	Loosen the needle clamp screw (D by turning it
	counterclockwise
	Remove the needle from the clamp(_)
[]	Insert a new needle into the needle clamp (_) with the flat
	side to the rear,
	When inserting the needle into the clamp, push it up as
	far as it goes Tighten the clamp screw 0 firmly by turning
	it clockwise
[]	To check for a good needle, placetheflat sideoftheneedle
	onto something flat (needle plate, glass,etc.) The gap
	between the needle and the flat surface should be consis
	tent Never use a bent or bluntneedle.
	A damaged needle can cause permanent snags
	or runs in knits, fine silks and silk-like fabrics

Changing Presser Foot

($) Lever

(_) Groove

(_) Pin

] To remove:

Turn the handwheel toward you to raise the needle to its highest position. Press the leverOon the back of the foot holder, The presser foot will drop off

[] To attache:

Place the presser foot so the pin (_)on the foot lines just under the groove(_) of the foot holder. Lower the foot holder to lock the foot in place

[][]

I

I

[]

f

[][]

10