Janome MB-4 manual Threading the Needle, Threading needle No.1

		Threading the Needle
	q	The threading path of all needles is similar. Review
		the threading procedure of the first needle when
		threading other needles.
	w	Threading needle No.1
z
		z Place a thread cone on the front right spool pin.
		Draw the thread up and pass it through the right
		hole in the thread guide bar from behind.
		Slip the thread under the tension leaf.
		q Hole in the thread guide bar
		w Tension leaf

u
x	x Draw the thread to the right pre-tension control.
e	Pass the thread through the guide hole from
	behind.
r	While holding the thread with both hands, slip the
	thread under the tension disk of the pre-tension
	control.
r	Hook the thread aroung the guide pin from right to
e	left.
t	Make sure to insert the thread under the tension
	disk by tugging the thread.

e Guide hole

r Pre-tension control t Guide pin

cv i

NOTE:

Refer to the illustration for the thread path of each pre-tension.

cPush back the tension release lever so the tension disk of the tension control will open.

y Tension release lever u Tension control

v Hold the thread with both hands and pull it down

yalong the right channel.

i Channel

u

19