Cleaning the Auto Thread Cutter Mechanism
z q | e | r | CAUTION: |
| |||
|
|
| |
w |
|
| Turn the power switch off before cleaning the auto |
|
| thread cutter mechanism. | |
|
|
| |
|
|
| z Loosen the 2 setscrews on the needle plate with |
|
|
| the offset screwdriver. |
|
|
| Unscrew and remove the 2 setscrews with the |
|
|
| screwdriver |
|
|
| q Setscrews |
|
|
| w Needle plate |
|
|
| e Offset screwdriver |
| t |
| r Screwdriver |
|
|
| |
| x |
| x Remove the needle plate. |
|
|
| Clean the auto thread cutter mechanism with the |
|
|
| lint brush. |
|
|
| t Auto thread cutter mechanism |
c |
|
| c Replace the needle plate and attach it with the 2 |
|
|
| setscrews. Tighten the setscrew slightly. |
| v |
| v Lower the needle bar by pushing it down with the |
ysmall screwdriver.
y Small screwdriver
b | b Turn the handwheel in the direction of “A” to |
A | lower the needle into the hole in the needle plate. |
n | n Adjust the position of the needle plate so that |
| needle enters into the center of the hole. |
| u Hole in the needle plate |
| u |
m | m Tighten the 2 setscrew securely with the offset |
| screwdriver. |
, | , Turn the handwheel in the direction of “B” to |
| raise the needle bar. |
B
78