Janome MB-4 manual Error Messages, Audible Signals, Audible signal Buzzer sounds when

Error Messages

	Error Message				Error Description	Remedy
					Communication error with the	Turn the power switch off and turn it on again.
		E : 00
					RCS unit
					Initializing error	Turn the power switch off and turn it on again.
					Needle bar switching error	Turn the power switch off and turn it on again.
					Needle bar stop position error	Press the ENTER button to reset the machine.
					Driving motor stops due to an	After 15 seconds, the LCD screen will show the
					overload.	Ready to Sew mode display. Remove jamming
						threads or other cause of overloading.
					Needle thread broke or ran	Press the MODE key to return to the Ready to
					out.	Sew mode and re-thread the needle.
					Needle bar setting error	Press the MODE button to return to the Ready to
						Sew mode then set the needle bar number.
					Auto thread cutting error	Turn the power switch off and turn it on again.
					Opening tension disks while	Pull the tension release lever to close the
					stitching	tension disks. The LCD screen will show the
						Ready to Sew mode display.
					Upper shaft stop position	Turn the power switch off and turn it on again.
					error
Audible Signals
Audible signal			The buzzer sounds when:
pip				Normal operation
pip-pip-pip-pip				Invalid operation or malfunction
pip-pip				Thread color change
pip-peep pip-peep				Embroidery completed
peep				Malfunction

80