Falcon U108610-07 Glass Fronted Door Panels, ‘Cook & Clean’ Panels, 5, 6 -7

Page 15
Before you remove any of the grill parts for cleaning,

Grill

The grill pan and trivet should be washed in hot soapy water. Alternatively, the grill pan can be washed in a dishwasher.

After grilling meats or any foods that soil, leave to soak for a few minutes immediately after use. Stubborn particles may be removed from the trivet using a nylon brush.

Before you remove any of the grill parts for cleaning,

nn

make sure that they are cool, or use oven gloves.

nnDO NOT use any abrasive substances.

Control Panel and Doors

Avoid using any abrasive cleaners including cream cleaners. For best results, use a liquid detergent.

The control panel, knobs and doors should only be cleaned with a soft cloth wrung out in clean hot soapy water – but take care that no surplus water seeps into the appliance.

After cleaning, polish with a dry cloth.

Glass Fronted Door Panels

The oven door front panels can be taken o￿ so that the glass panels can be cleaned. Move the cooker forward to gain access to the sides (see the ‘Moving the Cooker’ section under ‘Installation’).

Open the oven door slightly and remove the front panel ￿xing screws from the door sides, two each side (Fig.5-5).

Carefully lift o￿ the outer door panel. The inside face of the glass panels can now be cleaned – take care not to disturb or wet the door insulation.

Note: If the door is triple glazed then the inner two panels are ￿xed together and should not be separated.

After cleaning, carefully re￿t the outer door panel and replace the side ￿xing screws.

DO NOT use harsh abrasive cleaners or sharp metal

nn

scrapers to clean the oven door glass since they can scratch the surface, which may result in shattering of the glass.

Ovens

‘Cook & Clean’ Panels

The main oven has panels which have been coated with a special enamel that partly cleans itself. This does not stop all marks on the lining, but helps to reduce the amount of manual cleaning needed.

The ‘Cook & Clean’ panels work better above 200 °C. If you do most of your cooking below this temperature, occasionally remove the panels and wipe with a lint free cloth and hot soapy water. The panels should then be dried and replaced and the oven heated at 200 °C for about one hour. This will make sure the ‘Cook & Clean’ panels are working e￿ectively.

Do not use steel wool, oven cleaning pads, or any

nn

other materials that will scratch the surface.

Fig.5-5

ArtNo.320-0002a Proplus oven door side screws

Fig.5-6

Fig.5-7

ArtNo.320-0022 Tall oven side support

13

Page 14 Page 16
Image 15
Page 14 Page 16
Contents U108610-07 Installation InstructionsUser Guide 90 Dual FuelContents nnDO NOT use a steam cleaner to clean the cooker 1. Before You StartWARNING The appliance and its accessible parts surfaces To avoid overheating, DO NOT install the cookerDO NOT store ammable materials in the storage nnThis appliance is heavy so take care when moving itAlways keep combustible materials, e.g. curtains and ammable liquids a safe distance away from your cookerFig.2-1 2. Cooker OverviewHotplate Burners A B C DFig.2-7 Wok BurnerFig.2-3 Fig.2-4 Fig.2-5 Fig.2-6Always leave space around the griddle for the gases DO NOT put it crossways - it will not t properly andwill be unstable DO NOT put it on any other burner - it is not designed to t in any of the other pan supports Fig.2-12Fig.2-16 nnNever close the grill door when the grill is onArtNo.210-0001 Classic grill control Fig.2-15To Stop the Ovens Automatically Setting the Time of DayA B C D E F Minute MinderFig.2-32 AUTO is Showing, But you Want to Reset to Manual CookingKey Lock Fig.2-30Fig.2-31Fig.2-35 Oven Shelves - Left-hand Main OvenOven Shelves - Right-hand Tall Oven The Handyrack Main Ovenalready warm Tips on Cooking with the TimerGeneral Oven Tips DO NOT use the timed oven if the adjoining oven is4. Cooking Table The Wok Burner 5. Cleaning Your CookerDO NOT mix dierent cleaning products - they may The Single Ring BurnersDo not use steel wool, oven cleaning pads, or any ‘Cook & Clean’ PanelsBefore you remove any of the grill parts for cleaning DO NOT use harsh abrasive cleaners or sharp metalPart Recommended Cleaning MethodRemoving the Main Oven Linings HotplateNever use caustic or abrasive cleaners as these will 6. TroubleshootingHotplate ignition or hotplate burners faulty What cleaning materials are recommended for the cooker?An oven light is not working Fig.6-1 Fig.6-2Fig.6-3 Fig.6-4INSTALLATION 7. InstallationIf you Have a Problem Out of WarrantyFailure to install the appliance correctly could Installer’s Name Installer’s Company Installer’s Telephone NumberRead the instructions before installing or using this appliance AS 5601 - ‘Gas Installations’Checking the Parts You will also need the following toolsFig.7-1 1. Overhead - Measurement A2. Side Clearances - Measurements B & C 3. Side Clearances - Measurement D & Eplugged into the electricity supply Lowering the Two Rear RollersCompleting the Move On no account try and move the cooker while it isFitting the Restraining Chain Unless properly installed, the cooker could be tipped byFitting the Stability Bracket and Chain Fitting a Stability BracketPropane Pressure TestingGas Connection Natural GasFig.7-11 Fixed WiringA N Fig.7-10Fitting the Handles and Handrail Classic only Hotplate CheckGrill Check Oven CheckToledo - Removing the Control Panel 8. Conversion to LP GasWhen servicing or replacing gas-carrying Classic - Removing the Control PanelFig.8-4 WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON 9. Servicing1.1 To Remove the Control Panel 1.2 To Remove the Side Panels2.4 To Replace a Hotplate Burner Electrode 2.1 To Remove the Hotplate2.2 To Replace the Hotplate Control Taps 2.3 To Change a Hotplate Burner Injector4.1 To Replace the Grill Controller 3.1. To Replace the Ignition or Light Switch3.2 To Replace the Clock 3.3 To Change the Ignition GeneratorFig.9-4 Fig.9-5 5.3 To Change the Oven Element5.4 To Change an Oven Element Thermal Cut-out 5.5 To Replace an Oven Thermostat6.2 To Replace the Main Oven Door 6.3 To Adjust the Main Oven Door Angle6.6 To Adjust the Main Oven Door Catch Keep 6.1 To Remove the Grill Door6.10 To Change an Oven Door Seal 6.7 To Remove the Tall Oven Door6.8 To Replace the Tall Oven Door Outer Panel 6.9 To Replace the Tall Oven Door Magnetic Latch10. Circuit Diagram DescriptionColour COUNTRY OF DESTINATION Australia 11. Technical DataMaximum power output @ 230V 50 Hz Usable volume litresPage Page Clarence Street, Royal Leamington Spa Warwickshire, CV31 2AD, England Tel +44 0 1926 457400 Fax +44 0 1926E-mail consumers@falconappliances.co.uk
Top Page Image Contents