Falcon U108610-07 To Remove the Grill Door, To Replace the Main Oven Door, 9, 12

Page 34
Fig.9-6

Fig.9-6

Fig.9-7

1

 

2

 

 

ArtNo.320-0001 Door hinges

ArtNo.320-0001 Door hing

 

Fig.9-8

Centreline of hinge pin

Fig.9-8ArtNo.320-0007 Oven door hinge adjustment 2Fig.9-9

Oven door omitted for clarity

Fig.9-9

6 Doors

6.1To Remove the Grill Door

Remove the left-hand side panel (see 1.2). Remove the plinth (4 screws) and the central vertical cover (5 screws). Remove the 2 countersunk screws (1 each side) securing the grill hinge arms to the front of the grill chamber.

Note: The arms are spring tensioned. Carefully remove the grill door. Retain the gaskets.

Reassemble in reverse order, making sure that the gasket is ￿tted between the hinge arm and the front of the grill chamber.

6.2To Replace the Main Oven Door

Open the oven door. Support the door and loosen the 2 screws securing the upper hinge and gasket to the cooker front (Fig.9-6).

nnThe door is heavy, so take care.

Support the door and remove the screw nearest the hinge pin (Fig.9-7). Swing the hinge up and away from the door hinge pin. Lift the door away from the lower hinge and remove.

Reassemble in reverse order.

-0006 Oven door hinge

E￿ect of hinge adjustment – exagerrated for clarity

Fig.9-10

ArtNo.320-0002a Proplus oven door side screws

6.3To Adjust the Main Oven Door Angle

The bottom hinge of the main oven door can be adjusted to alter the angle of the door (Fig.9-8). Loosen the bottom hinge ￿xing screws and use the notch and a ￿at bladed screwdriver to move the position of the hinge to set the hinge position (Fig.9-9).

Retighten the hinge screws.

6.4To Replace the Main Oven Door Outer Panel

Move the cooker forwards to gain access to the sides.

Open the main oven door slightly and remove the

4 front panel ￿xing screws from the door sides (2 each side), (Fig.9-10). Carefully lift o￿ the outer door panel.

Remove the door handle from the panel by unscrewing the 2 retaining nuts.

Fit the door handle to the new panel.

Fit the panel to the door. Reassemble in the reverse order.

 

 

6.5 To Change the MainOven Door Latch

Fig.9-11

Fig.9-12

Remove the main outer door panel (see 6.4). Remove

 

ArtNo.320-0004 Oven door keep

screws ‘B’, which hold the latch assembly to the inner

 

 

door panel (Fig.9-11). Fit the new catch and reassemble

 

 

in reverse order. Check the door operation.

B 6.1To Remove the Grill Door

ArtNo.320-0003 Oven door latch

6.6To Adjust the Main Oven Door Catch Keep

Open the main oven door, slacken o￿ the locknut at the base of the keep, and screw in or out as required until the required ￿t is obtained. Retighten the locking nut (Fig.9-12).

32

Page 33 Page 35
Image 34
Page 33 Page 35
Contents 90 Dual Fuel Installation InstructionsUser Guide U108610-07Contents surfaces To avoid overheating, DO NOT install the cooker 1. Before You StartWARNING The appliance and its accessible parts nnDO NOT use a steam cleaner to clean the cookerand ammable liquids a safe distance away from your cooker nnThis appliance is heavy so take care when moving itAlways keep combustible materials, e.g. curtains DO NOT store ammable materials in the storageA B C D 2. Cooker OverviewHotplate Burners Fig.2-1Fig.2-5 Fig.2-6 Wok BurnerFig.2-3 Fig.2-4 Fig.2-7designed to t in any of the other pan supports Fig.2-12 DO NOT put it crossways - it will not t properly andwill be unstable DO NOT put it on any other burner - it is not Always leave space around the griddle for the gasesFig.2-15 nnNever close the grill door when the grill is onArtNo.210-0001 Classic grill control Fig.2-16Minute Minder Setting the Time of DayA B C D E F To Stop the Ovens AutomaticallyFig.2-30Fig.2-31 AUTO is Showing, But you Want to Reset to Manual CookingKey Lock Fig.2-32The Handyrack Main Oven Oven Shelves - Left-hand Main OvenOven Shelves - Right-hand Tall Oven Fig.2-35DO NOT use the timed oven if the adjoining oven is Tips on Cooking with the TimerGeneral Oven Tips already warm4. Cooking Table The Single Ring Burners 5. Cleaning Your CookerDO NOT mix dierent cleaning products - they may The Wok BurnerDO NOT use harsh abrasive cleaners or sharp metal ‘Cook & Clean’ PanelsBefore you remove any of the grill parts for cleaning Do not use steel wool, oven cleaning pads, or anyHotplate Recommended Cleaning MethodRemoving the Main Oven Linings PartWhat cleaning materials are recommended for the cooker? 6. TroubleshootingHotplate ignition or hotplate burners faulty Never use caustic or abrasive cleaners as these willFig.6-4 Fig.6-1 Fig.6-2Fig.6-3 An oven light is not workingOut of Warranty 7. InstallationIf you Have a Problem INSTALLATIONAS 5601 - ‘Gas Installations’ Installer’s Name Installer’s Company Installer’s Telephone NumberRead the instructions before installing or using this appliance Failure to install the appliance correctly couldYou will also need the following tools Checking the Parts3. Side Clearances - Measurement D & E 1. Overhead - Measurement A2. Side Clearances - Measurements B & C Fig.7-1On no account try and move the cooker while it is Lowering the Two Rear RollersCompleting the Move plugged into the electricity supplyFitting a Stability Bracket Unless properly installed, the cooker could be tipped byFitting the Stability Bracket and Chain Fitting the Restraining ChainNatural Gas Pressure TestingGas Connection PropaneFig.7-10 Fixed WiringA N Fig.7-11Oven Check Hotplate CheckGrill Check Fitting the Handles and Handrail Classic onlyClassic - Removing the Control Panel 8. Conversion to LP GasWhen servicing or replacing gas-carrying Toledo - Removing the Control PanelFig.8-4 1.2 To Remove the Side Panels 9. Servicing1.1 To Remove the Control Panel WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON2.3 To Change a Hotplate Burner Injector 2.1 To Remove the Hotplate2.2 To Replace the Hotplate Control Taps 2.4 To Replace a Hotplate Burner Electrode3.3 To Change the Ignition Generator 3.1. To Replace the Ignition or Light Switch3.2 To Replace the Clock 4.1 To Replace the Grill Controller5.5 To Replace an Oven Thermostat 5.3 To Change the Oven Element5.4 To Change an Oven Element Thermal Cut-out Fig.9-4 Fig.9-56.1 To Remove the Grill Door 6.3 To Adjust the Main Oven Door Angle6.6 To Adjust the Main Oven Door Catch Keep 6.2 To Replace the Main Oven Door6.9 To Replace the Tall Oven Door Magnetic Latch 6.7 To Remove the Tall Oven Door6.8 To Replace the Tall Oven Door Outer Panel 6.10 To Change an Oven Door SealDescription 10. Circuit DiagramColour Usable volume litres 11. Technical DataMaximum power output @ 230V 50 Hz COUNTRY OF DESTINATION AustraliaPage Page Tel +44 0 1926 457400 Fax +44 0 1926 Clarence Street, Royal Leamington Spa Warwickshire, CV31 2AD, EnglandE-mail consumers@falconappliances.co.uk
Top Page Image Contents