Falcon U108610-07 To Replace the Ignition or Light Switch, To Replace the Clock, Main Oven

Page 32
3.1.To Replace the Ignition or Light Switch

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON

Disconnect from electricity before servicing. Check appliance is safe when you have ￿nished.

3 Controls

3.1.To Replace the Ignition or Light Switch

DISCONNECT FROM THE ELECTRICITY SUPPLY. Remove the control panel (see 1.1).

Note: The old switch may be destroyed during removal. Remove the old switch from its bezel by gripping the switch body behind the control panel and twisting sharply. Remove the switch bezel by folding back the locking wings and pushing forward.

To ￿t the new bezel to the control panel: ￿rst line up the raised key on its body with the cut-out in the control panel and push it in from the front.

Assemble the new switch to the bezel by lining up the key sections and pushing home. Fit the new button by pushing in from the front.

Replace the control panel in the reverse order and test for correct operation.

3.2To Replace the Clock

DISCONNECT FROM THE ELECTRICITY SUPPLY.

Remove the control panel (see 1.1). Pull o￿ the timer control buttons.

Undo the timer ￿xing screws and remove the timer/ mounting bracket assembly from the control panel.

Remove the timer from its mounting bracket by depressing the plastic lugs on the timer case, and at the same time pulling the unit forward.

Reassemble in reverse order. When replacing the leads, refer to the wiring diagram. Check the operation of the timer.

3.3To Change the Ignition Generator

DISCONNECT FROM THE ELECTRICITY SUPPLY.

Pull the cooker forwards to gain access to the cover box at the rear of the cooker. Remove the screws securing the cover and lift clear. Pull o￿ all the leads to the generator noting their positions. Slacken the 2 screws holding generator to cooker and remove the generator.

Fit the new generator to the cooker and replace the leads. Refer to the wiring diagram and reassemble in reverse order. Check ignition performance.

4 Grill

4.1To Replace the Grill Controller

DISCONNECT FROM THE ELECTRICITY SUPPLY.

Remove the control panel and hotplate (see 1.1 & 2.1). Disconnect the wiring from controller. Remove the

2 screws holding the controller to the mounting panel.

Fit the new controller and reassemble in the reverse order. Check for correct operation.

4.2To Replace the Grill Element

DISCONNECT FROM THE ELECTRICITY SUPPLY.

Remove the grill pan from the grill chamber. From inside the grill compartment, undo the 2 screws and washers and remove the enamelled front shield from the grill roof. Remove 2 screws and washers securing the grill element front support. Remove the screws from the grill elements.

Carefully lift the elements out and disconnect the leads from the element terminals, noting their position.

If it is not possible to disconnect the leads in this way, pull cooker forwards to gain access to the rear.

Remove the screws securing the electric cover to the back sheet, and then remove cover and disconnect the terminals from the rear.

Fit the new elements and reassemble in reverse order. Check the operation of the grill.

5 Ovens

5.1To Remove the Oven Inner Back

Main Oven

Open the main oven door. Remove the 4 screws and washers securing the inner back to the back of the oven (Fig.9-4). Carefully lift away the inner back.

Reassemble in reverse order, making sure that you fully tighten the 4 screws and washers.

Tall Oven

Open the tall oven door and remove the 2 screws and washers securing the inner back to the back of the oven. Carefully lift away the inner back.

Reassemble in reverse order.

Check the door for correct operation.

5.2To Change the Oven Fan

DISCONNECT FROM THE ELECTRICITY SUPPLY.

Pull the cooker forward to gain access to the rear. Remove the screws securing the electric cover to the back sheet and remove the cover. Disconnect the

3 terminals connected to the fan, noting their position.

Remove the oven inner back (see 5.1). Hold the fan blade and remove the centre nut (left-hand thread),

2 brass washers, fan blade and circlip. Unscrew the fan retaining nuts and washers (3 o￿ each) and lift the fan away from the rear of the cooker.

30

Page 31 Page 33
Image 32
Page 31 Page 33
Contents Installation Instructions User Guide90 Dual Fuel U108610-07Contents 1. Before You Start WARNING The appliance and its accessible partssurfaces To avoid overheating, DO NOT install the cooker nnDO NOT use a steam cleaner to clean the cookernnThis appliance is heavy so take care when moving it Always keep combustible materials, e.g. curtainsand ammable liquids a safe distance away from your cooker DO NOT store ammable materials in the storage2. Cooker Overview Hotplate BurnersA B C D Fig.2-1Wok Burner Fig.2-3 Fig.2-4Fig.2-5 Fig.2-6 Fig.2-7DO NOT put it crossways - it will not t properly and will be unstable DO NOT put it on any other burner - it is notdesigned to t in any of the other pan supports Fig.2-12 Always leave space around the griddle for the gasesnnNever close the grill door when the grill is on ArtNo.210-0001 Classic grill controlFig.2-15 Fig.2-16Setting the Time of Day A B C D E FMinute Minder To Stop the Ovens AutomaticallyAUTO is Showing, But you Want to Reset to Manual Cooking Key LockFig.2-30Fig.2-31 Fig.2-32Oven Shelves - Left-hand Main Oven Oven Shelves - Right-hand Tall OvenThe Handyrack Main Oven Fig.2-35Tips on Cooking with the Timer General Oven TipsDO NOT use the timed oven if the adjoining oven is already warm4. Cooking Table 5. Cleaning Your Cooker DO NOT mix dierent cleaning products - they mayThe Single Ring Burners The Wok Burner‘Cook & Clean’ Panels Before you remove any of the grill parts for cleaningDO NOT use harsh abrasive cleaners or sharp metal Do not use steel wool, oven cleaning pads, or anyRecommended Cleaning Method Removing the Main Oven LiningsHotplate Part6. Troubleshooting Hotplate ignition or hotplate burners faultyWhat cleaning materials are recommended for the cooker? Never use caustic or abrasive cleaners as these willFig.6-1 Fig.6-2 Fig.6-3Fig.6-4 An oven light is not working7. Installation If you Have a ProblemOut of Warranty INSTALLATIONInstaller’s Name Installer’s Company Installer’s Telephone Number Read the instructions before installing or using this applianceAS 5601 - ‘Gas Installations’ Failure to install the appliance correctly couldYou will also need the following tools Checking the Parts1. Overhead - Measurement A 2. Side Clearances - Measurements B & C3. Side Clearances - Measurement D & E Fig.7-1Lowering the Two Rear Rollers Completing the MoveOn no account try and move the cooker while it is plugged into the electricity supplyUnless properly installed, the cooker could be tipped by Fitting the Stability Bracket and ChainFitting a Stability Bracket Fitting the Restraining ChainPressure Testing Gas ConnectionNatural Gas PropaneFixed Wiring A NFig.7-10 Fig.7-11Hotplate Check Grill CheckOven Check Fitting the Handles and Handrail Classic only8. Conversion to LP Gas When servicing or replacing gas-carryingClassic - Removing the Control Panel Toledo - Removing the Control PanelFig.8-4 9. Servicing 1.1 To Remove the Control Panel1.2 To Remove the Side Panels WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON2.1 To Remove the Hotplate 2.2 To Replace the Hotplate Control Taps2.3 To Change a Hotplate Burner Injector 2.4 To Replace a Hotplate Burner Electrode3.1. To Replace the Ignition or Light Switch 3.2 To Replace the Clock3.3 To Change the Ignition Generator 4.1 To Replace the Grill Controller5.3 To Change the Oven Element 5.4 To Change an Oven Element Thermal Cut-out5.5 To Replace an Oven Thermostat Fig.9-4 Fig.9-56.3 To Adjust the Main Oven Door Angle 6.6 To Adjust the Main Oven Door Catch Keep6.1 To Remove the Grill Door 6.2 To Replace the Main Oven Door6.7 To Remove the Tall Oven Door 6.8 To Replace the Tall Oven Door Outer Panel6.9 To Replace the Tall Oven Door Magnetic Latch 6.10 To Change an Oven Door SealColour 10. Circuit DiagramDescription 11. Technical Data Maximum power output @ 230V 50 HzUsable volume litres COUNTRY OF DESTINATION AustraliaPage Page E-mail consumers@falconappliances.co.uk Clarence Street, Royal Leamington Spa Warwickshire, CV31 2AD, EnglandTel +44 0 1926 457400 Fax +44 0 1926
Top Page Image Contents