Black & Decker BDH2000L Operation, Switching on and off, Cleaning and emptying the product

• Leave the appliance to charge.

If the appliance detects a damaged battery, the charging indicator will flash at a fast rate when the appliance is on the charger base. Proceed as follows:

• Take the appliance and the charger to be tested at an authorized service facility.

Note: It may take as long as 60 minutes to determine that the battery is defective. If the battery is too hot or too cold, the LED will alternately blink, fast and slow, one flash at each speed and repeat.

OPERATION

Switching on and off

• Figure B - To start, slide the On/Off switch forward (i.e. “O”= Off, “I” = On).

• To stop, slide the switch back.

• Return the product to the charger immediately after use so that it will be ready and fully charged for the next use. Ensure that the product is fully engaged with the charger base.

B

Cleaning and emptying the product

WARNING: Projectile/Respiratory Hazard: Never use the vac without its filter. NOTE: The filter is re-usable, do not confuse it with a disposable dust bag, and do not throw it away when the product is emptied. We recommend that you replace the filter every 6-9 months depending on frequency of use.

There are two methods of cleaning the bowl, a quick empty method and a thorough clean method.

For a quick empty (figures C,D)

• Figure C - Press in on both nozzle release buttons on the sides of the nozzle and remove the nozzle by pulling straight off.

C

•Figure D - Empty the dust from the bowl.

•For a more thorough cleaning, remove bowl as described in figures E, F, & G.

D

5