Brocade Communications Systems SBCEBFCSW manual Electromagnetic compatibility notices USA

Page 12

Electromagnetic compatibility notices (USA)

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his/her own expense.

NOTE

Class A device definition: If a Class A device is installed within the is system, then the system is to be considered a Class A system. In this configuration, operation of this equipment in a residential area is likely to cause harmful interference.

NOTE

This product is intended to be installed with CAT5 cable, or equivalent, to minimize electrical interference.

Electromagnetic compatibility notices (International)

Europe (CE Declaration of Conformity): This product has been tested in accordance too, and complies with the Low Voltage Directive (73/23/EEC) and EMC Directive (89/336/EEC). The product has been marked with the CE Mark to illustrate its compliance.

Japan EMC Compatibility:

English translation of the notice above: This is a Class A product based on the standard of the Voluntary Control Council for Interference by Information Technology Equipment (VCCI). If this equipment is used in a domestic environment, radio disturbance may arise. When such trouble occurs, the user may be required to take corrective actions.

ICES-003 (Canada): Cet appareil numérique respecte les limites bruits radioélectriques applicables aux

appareils numériques de Classe A prescrites dans la norme sur le matériel brouilleur: "Appareils Numériques", NMB-003 édictée par le Ministre Canadian des Communications.

English translation of the notice above: This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the interference-causing equipment standard entitled "Digital Apparatus," ICES-003 of the Canadian Department of Communications.

xii

Brocade SAN Switch Module: Installation Guide

Image 12
Contents Sbcebfcsw Brocade SAN Switch Module Installation Guide Contents Brocade SAN Switch Module Installation Guide Safety and regulatory information General Safety Electrical SafetyHandling electrostatic discharge-sensitive devices Viii Use safe practices when lifting Xx Caution Regulatory specifications and disclaimers Safety complianceElectromagnetic compatibility notices USA Xiii Xiv Brocade Enterprise SAN Switch Module Sbcebfcsw for Intel Features and specifications Resource CDPage Fibre Channel switch-module standards and protocols Dimensions SFP module at 2 Gbps Mode Related documentationPage Major components of the switch module Shows the major components of the switch moduleFibre Channel switch-module major components Brocade SAN Switch Module Installation Guide Installing and replacing a switch module Installation guidelines Bay Fibre Channel switch-module functionInstalling a switch module Handling static-sensitive devicesRemoving the acoustic attenuation module Squeezing the release-lever latch Installing a switch module Removing or replacing a switch module Removing a switch module Page Brocade SAN Switch Module Installation Guide Information panel LEDs and external Fibre Channel ports Information panelLEDs Fibre Channel switch-module LEDs. Notes Port speed Green Off Configuring the switch module through the Telnet interface Connecting to the switch moduleEnter Network Password window Establishing a Telnet session through the management moduleManagement-module main window Switch Management window showing switch-module 3 example Management-module password-change window Establishing a Telnet session in a command-line window Management-module command-line interface windowTelnet command-prompt window Brocade SAN Switch Module Installation Guide Connecting to the switch module Active Session from Same Client window Management-module main window Switch Management window showing switch module 3 example Establishing a Web-interface session through a Web browser Advanced Web Tools interface window management-module viewAdvanced Web Tools interface window Web-browser view Optional features Brocade SAN Switch Module Installation Guide Getting Help and Technical Assistance Before you callBrocade SAN Switch Module Installation Guide